58715412100A Kenmore Dishwasher - Instructions

Less than 1 minute to remove old part and install new fence

Wheel, no problems

The video show a different model, the only difference is that the screws for the top part shouldn't be removed only the ones that hold the front. Replace the detergent dispenser once the cover is removed is easy. All works like brand new. Thanks.

The upper dish rack replacement is a direct replacement/exact fit. The only part needed to move from old/worn dish rack was the sprayer/tube assembly that is attached to bottom of dish rack. No tools required. Just push out and replace on new part.

Upper dishwasher rack easily removes off roller arms with upward tilt. Upper water tube/spray arm assembly unsnap from old rack and snaps onto new rack... no tools needed. Lucky enough new height adjustment levers come with new rack and with firm push they snap into place also. Stemware holder also unsnapped off old rack and then snapped onto new rack. Upper rack returned to dishwasher with upward tilt and threaded back on roller arms. Easy peasy. Done.

1. Watch YouTube videos, even though they're different model dishwashers. NOTE: all replacement racks are not OEM, they're cheap imitations, thinner material, not original design for holding dishware.
2. Replace rusted upper rack, rack simply lifts out; no need to remove rail end caps.
3. Carefully remove attachments from original basket ( no tools were required), be especially careful detaching the upper spray arm from the underside of the basket.
4. Attach previously removed original attachments (not all would fit because of replacement rack design). Attach upper spray arm.
5. Reinsert replacement basket into upper rails.

Needed to replace detergent / rinse aid dispenser unit on the inside top of door.

1) Need to remove outer door cover / panel by removing just two (2) screws - bottom screws on lower side panel. Door panel will drop vertically 1" to remove it.

2) Mark and disconnect the four (4) wires connected to the dispenser unit. The connections were so tight, it required pliers and a screw driver to loosen them.

3) Dispenser unit has four (4) screws holding it in place. Unscrew them and remove unit through door interior - this requires a bit of angling to get it out.

4) Position new unit through interior. Screw in place.

5) Re-attach four (4) wires in same sequence as disconnected.

6) Re-attach outer door cover. This is the most difficult part and really requires two people. It consistents of two sets of guide channels that most be aligned for the door panel to be secured re-attached.. Once aligned, the door cover must be moved vertically about an 1" and the screws re-attached.

unplug dishwasher.turn water valves under sink off. remove water line from dishwasher at hot water valve. remove evacuation hose from drain.remove support brackets securing dishwasher to counter top. slide dishwasher from under counter. put a sandwich bag over water line and drain line and secure with a rubber band so they don't leak onto floor. turn machine upside down. unplug motor wiring pigtail. remove 4 screws remove motor. reverse process to install. suggest using a silicone lubricant on o rings for easier install. took old motor apart found front bearing seized due to faulty front seal. hopefully this has been upgraded.

Turned power supply off to dishwasher Opened door and removed screws holding font of door Unplugged soap dispenser and removed six screws. Popped out and installed new dispenser. Plugged wires into new dispenser and installed front of door. Easy

Lift out old basket replace with new basket

Located a YouTube video and it was easy to remove and clean the filter and install the basket

open door
place holder in the sliding component
close door

The replacement basket fit perfectly.

Took the new Silverware Basket from the box. Opened door to dishwasher, removed defective Silverware Basket, put new Silverware Basket in its place.

Dropped in new basket