58714144400 Kenmore Dishwasher - Instructions

I just had to buy a new cap and screw it in.

There were 4 zip ties holding old silverware basket on to bottom rack snip them, remove basket install new basket with zip ties both ends 2 more in middle about 1-2” apart. Try to install ties about 1/2 way up on basket so it doesn’t get top heavy.

Looseing up rack wheeles took out keepers slid in new rack put in keepers and tighten wheel nuts make sure there tight thats it easy a baby can do it.

replaced the pump

Simply unscrewed the old. Replaced with the new.

The first sensible thing to do is to find the circuit breaker for your dishwasher and switch it off so as not to short anything (or yourself) out. Next, remove the lower piece of metal bracket from beneath the door by unfastening the two sheet metal screws (a nut driver or a screwdriver will do the job), taking note as to how it comes off so as to facilitate replacement. Some will recommend loosening the screws at the top from beneath the counter and pulling the machine forward a bit to gain access to the sides but, if you have a small enough hand (as I do), you can just reach in there and and hook the spring into place. I didn't want to risk loosening any plumbing! You'll need a flashlight to see where the ends connect. And, if one spring is still intact, you can reference that to reassure yourself you've got it right. I was able to stretch the spring out by hand and hook the thing to that little plastic gadget that pivots when you open the door. That's it! Button her up! You're done!

Disconnected water and power. Two screws secured pump. Simply disconnect and reconnect. Perfectly quiet and operational. Great easy fix!!!

Pull the old parts out put new ones in..Changed bottom door seal and door tub gasket. In about 20 minutes.

on a U-TUBE repair sequence it showed removing the entire front panel of the door. With this Kenmore model the front panel is in two parts. The upper part where the controls and latch are is independent of the front panel so all I needed was to unscrew the upper panel, unscrew the latch, pull off the wires and reinstall by plugging in the wires, screwing the new latch to the door, reinstalling the panel to the door. It took about 15-20 minutes for the entire operation.

first open door and removed 8 philips screws, removed inside panel and changed lower door gasket.then reassembled in reverse order of removal.second used plyers removed tub gasket matched up to new gasket and cut to length to match old gasket.clean track on tub and install same way old gasket was in, make sure gasket is seated evenly.clean up and run dishwasher check for leaks.

replacing 2 wheels was a breeze. did not need the screws afterall.

Replaced two springs

Grabbed edge of one end and pulled seal out and cleaned the area of water stains and etc. , Then pushed new seal into place. . . . .

Just snapped the wheels on and attached the bracket to the existing part.

Removed two screws on each side, lower half. Inside, removed six screws. Replaced the assembly and replaced all screws.
Not worth the fifty dollars for the part, just to have a door open at the right time to empty soap. Quite a hefty price to pay considering the price of the machine