5871541590 Kenmore Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Lloyd from Wyomissing, PA
- Parts Used:
- 5300809703
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Dishwasher door more difficult to open and close
Removed two screws holding the dishwasher in place under the cabinet. Pulled the dishwasher out to expose the door springs. Removed the old springs and installed the new ones in just a few minutes. Pushed the dishwasher back into the cabinet and replaced the screws. Job done.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Vincent from East Stroudsburg, PA
- Parts Used:
- 5304532229
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broken rack rollers
Two rollers on the lower rack were missing and one was flattened. I popped off the bad roller and snapped the three new rollers in place, all by hand. Took about 60 seconds.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Christopher from Pensacola, FL
- Parts Used:
- 5300809703
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Door Spring broken, door hard to close.
I removed two screws that hold unit to countertop,
just pulled out unit about two inches. Removed broken door springs. Installed new door springs and pushed unit back into place and installed the 2 countertop screws DONE.
just pulled out unit about two inches. Removed broken door springs. Installed new door springs and pushed unit back into place and installed the 2 countertop screws DONE.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Russell from Gurnee, IL
- Parts Used:
- 5300809703
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Wrench set
Broken door spring
In about 20 minutes, I was able to remove the front panel and access the springs. Besides a hard water line in the way, it was a snap.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Carol from Duncanville, TX
- Parts Used:
- 5300809703
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Door spring broke
Removed the service panel below the door (4 hex-head screws), then reached in and took the old broken spring out (right side) and hooked the new one up.
Glad I bought 2 springs - the other one (left side) broke about a week after I fixed the first one! Replaced it the same way. Helps to have small hands - you can't really see where you're putting the springs but can feel where they should go.
Glad I bought 2 springs - the other one (left side) broke about a week after I fixed the first one! Replaced it the same way. Helps to have small hands - you can't really see where you're putting the springs but can feel where they should go.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Juergen from Shelbyville, IN
- Parts Used:
- 5300809703
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Door spring was broken
I removed the front panel below the door. There are 4 Hex screws, two at the top (accessible with the door open) and two at the bottom. After removing the screws, the panel came off, and I could reach inside to replace the springs. I found it easier to use a socket wrench than a screw driver.
Easily done. Anybody can do it. It took longer to clean up the panel than to do the actual repair.
Easily done. Anybody can do it. It took longer to clean up the panel than to do the actual repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barb from Bryan, OH
- Parts Used:
- 5300809611
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
The seal in the door was broken.
I had to replace the door gasket but it would not go in very easy..So I put the gasket in a sink of warm water so it would be more pliable. Then it went on fairly easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Harold from Amarillo, TX
- Parts Used:
- 5300809703, 5300809611
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers
Door sagging when open & sever water leak from door.
The parts arrived 20 hours after ordering -great service & the parts were just like like the removed parts only new. The old door gasket was pulled from its groove & and the new gasket was installed witout using tools. No more leaking water.The door spring installation wesa bit more difficult. The front bottom was removed with a nut drive, the broken springs were fished out, new springs were pull onto the arms and the cover put back in place. Not a bad job for a crippled, one-eyed 82 year old man.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andy from Aptos, CA
- Parts Used:
- 5304532229
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
There were no wheels on the bottom rack of our dishwasher.
This could not have gone easier! As long as you get the proper parts it's a piece of cake. I wish everything was this easy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Patricia from Alpharetta, GA
- Parts Used:
- 5304532229
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
broke the wheel
merely snapped the part on
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mitchell from Philadelphia, PA
- Parts Used:
- 5304532229
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken & missing wheels on lower rack
Installed New rollers onto bottom rack. Part order & delivery were top notch from Partselect. Will definitely order from them again.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Chaney from Batesville, AR
- Parts Used:
- 5304532229
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Missing lower rack roller
Fisrt, I opened dishwasher door. I then pulled out the lower rack & put new part in place and pushed in lower rack. Last, I closed dishwasher door.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gregory from Pickerington, OH
- Parts Used:
- 5300809703, 5300809611
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
My Diswasher was leaking from around the door gasket.
I ordered a new door gasket and door spring. I unscrewed the two screws that hold the dishwasher in place and pulled it out. I pulled the old broken spring off with pliers and installed the new one ,,,very easy. I then took the new door gasket and soaked it in hot water in the sink for 15 min. That made it very soft and pliable to work with. I used pliers to pull the old gasket out then cleaned the area around the old gasket where crud had built up. I pushed in the new gasket working from top to bottom one side at a time. Turned it on an ran through a cycle and it works perfect now ,,,no leaks.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kathy from Greer, SC
- Parts Used:
- 5304532229
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
lower rack rollers were missing
Rollers just snapped on the diswasher rack. Took just seconds to do.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barbara from Highland Park, IL
- Parts Used:
- 5304532229
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken Wheels On Lower Dish Rack
Just a littlr snap in the right place and perfection!
Was this instruction helpful to you?
Thank you for voting!