6651677991 Kenmore Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Gregory from North Port, FL
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Water leaking from front door of dishwasher
Took less than 5 minutes. Pried edge of old door seal out with a flathead screwdriver, then slowly pulled out old seal. Thoroughly cleaned area for new seal with rubbing alcohol, inserted new seal and trimmed the end to fit just right. Presto, no leaks whatsoever!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Debra from York, PA
- Parts Used:
- WP3378134
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Cap did not stay in the hole any longer.....was melted
Just screwed the new cap in. This PartSelect was AWESOME. So easy. Lighting fast shipping !!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- mike from Auburn, AL
- Parts Used:
- WP3369193
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers
The corners of the panel were the screws hold the cover onto the appliance had broken.
When the new part arrived I had to swap over the bottom metal plate that secures the bottom of the cover and also had to swap over the decorative front plate and top edge. The part worked wonderfully the job was very easy. The only thing I forgot to check on was the color of the part. I needed white and I ordered black, but that also was no big deal as the covers from the old part was white and covered it up. I will be using Partselect in the future and would recommend them to friends.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kathy from Chapel Hill, TN
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
door leaked
removed old seal, placed new seal in place. Used my fingers to push it in place. It didn't work as it still leaks. I've put vaseline on the seal and door and it helps but still leaks. The dishwasher doesn't overfill, so I still have the problem, just not as bad.
Was this instruction helpful to you?
Thank you for voting!
Soap Lid Pin Broken
Snap the old lid off, remove the pin & spring & install new Pin & Spring. Very easy. Thanks To Parts Select got the right parts.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steven from Lexington, NC
- Parts Used:
- 3373360
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Broken upper rack clips
Removed the rack and the broken clips. Replaced the clips. Reinstalled the rack.
Can't tell you how pleased I am with the service you have provided.
Can't tell you how pleased I am with the service you have provided.
Was this instruction helpful to you?
Thank you for voting!
Color didn't match updated look
First I removed the the rubber sides. Then I slide the replacement panel over the exisiting one. That's it no other tools were needed. I didn't even break a sweat.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bennett from Fayetteville, NC
- Parts Used:
- 3369447
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
dishwasher will not work,
one screw held the switch in place and is located at the front left of the machine at the bottom access panel, the new part was exactly as the old, the wires pulled off easy and plugged in to the new with no problem, switch still makes a noise and did not fix the problem, my fault not yours. Timer is moving thru the cycle but machine does no run or water flow in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- BRIAN from GOWANDA, NY
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
door seal leaked steam
It was a very simple repair. I removed the old door seal out of the track and installed the new seal.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Randy from Houston, TX
- Parts Used:
- 3374503
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers
Dishwasher failed to navigate cycles.
Removed back plastic panel ( 6 screws) from front steel facing( beauty panel). Pulled and put aside back interior plastic panel affixed to beauty panel. Front steel panel still in place. Removed cover plate on back of remaining beauty panel protecting electrical components affixed with plastic keepers ,with a screwdriver. I then yanked old timer and replaced with the new one. Cake walk, since the original timer and the new one had all the leads in one plastic fitting. Thanks for you help! Hope this account aids someone else!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- dwight from onaka, SD
- Parts Used:
- WP3372028
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
I broke one part trying to install
no tools necessary buy instructions would have brrn helpful
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ROSE from ELVERSON, PA
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
water was leaking ou the door
pulled the old door seal off and pushed the new seal into place and it works great!
THANK YOU!
THANK YOU!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Crystal from Bowman, GA
- Parts Used:
- WP3369769
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Front door panel was missing
I removed the cardboard insert, put the new front panel on and replaced the tabs. That was it!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- john a from west seneca, NY
- Parts Used:
- WPW10509257
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
leaking around door
1-2-3 EASIEST JOB I EVER HAD to DO AND THE WIFE IS PROUD OF ME FINALLY.
THANKS , , ,Bat from WEST SENECA (Buffalo, NY)
THANKS , , ,Bat from WEST SENECA (Buffalo, NY)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bob from Carlsbad, CA
- Parts Used:
- WP3378138
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
The detergent door won't open fully
Sorry, probably need a spring as the door is fine. While reading other stories about how hard the spring was to get right, I assumed the spring was part of the door assembly.
I'll be calling and returnint the part.
i'
I'll be calling and returnint the part.
i'
Was this instruction helpful to you?
Thank you for voting!