66516989200 Kenmore Dishwasher - Parts

If your dishwasher door is not opening or closing properly, it may be time to install a new balance kit. This part helps to support the weight of the door as it opens and closes. You should also check...

This is a single rack track stop clip used to prevent the upper dish rack from sliding all the way out of the dishwasher. It is made of gray plastic and can wear with time. This is an easy repair that...

The mounting bracket is used to secure the top part of your dishwasher to the underside of your counter or cabinet. If you have solid surface counters (granite, quartz, etc.) you will likely need to s...

This is a genuine OEM replacement silverware basket for your dishwasher. The basket measures approximately 19.5 inches long, 4 inches wide, and 9 inches high. It is made of gray-colored plastic and in...

If you are unable to smoothly roll the top dish rack of your dishwasher, you may need to replace some of the wheel assemblies. Over time they can become cracked and damaged, and once this happens, the...

When replacing these fuses the wire harness must be replaced as well. It is located in the control panel. The harness is included with this part now.

The door gasket provides a water tight seal, between the tub and the door, to keep water from leaking out of your dishwasher. If the dishwasher is leaking you may need to replace the door gasket. Thi...

This part releases the detergent and rinse aid into the dishwasher.

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve will open and close according to the desired amount of water needed.

Sold individually.

Sold individually. Used with the heating element.

This dishwasher door spring is sold individually. It is recommended if you are replacing one side, to replace both.