66512772K311 Kenmore Dishwasher - Parts

The retainer clip is used to hold the access panel on your dishwasher in place. It is a genuine OEM part that is black in color and sold individually. The only tool required to complete the repair is ...

If your dishwasher has started leaking, there may be an issue with the door seal. This genuine OEM replacement part measures approximately 22 inches long and 2 inches wide. The seal is made of plastic...

This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

This part is used to hold the access panel in place. Sold individually.

This door latch secures the dishwasher door and signals the control board when closed, allowing the cycle to begin. If the door won’t latch or the dishwasher won’t start, the latch may be faulty. Comp...

Sold individually.

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

This part is used to drain water from your dishwasher.

This hose clamp is sold individually.

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, ...

This part is also known as a float switch. This float switch, when activated, stops the flow of water into the dishwasher.

This part has a swivel gooseneck fitting and that allows it to be installed closer to the wall. This part has a 3/4" hose thread on one side and a 3/8" copper tubing on the other side.