66512782K311 Kenmore Dishwasher - Parts

If your dishwasher door is not opening or closing properly, it may be time to install a new balance kit. This part helps to support the weight of the door as it opens and closes. You should also check...

The mounting bracket is used to secure the top part of your dishwasher to the underside of your counter or cabinet. If you have solid surface counters (granite, quartz, etc.) you will likely need to s...

Prevent leaks and maintain optimal cleaning performance with this durable dishwasher door seal. It creates a secure barrier to keep water contained during wash cycles, ensuring reliable operation. Rep...

If your dishwasher has started leaking, there may be an issue with the door seal. This genuine OEM replacement part measures approximately 22 inches long and 2 inches wide. The seal is made of plastic...

This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

This seal is attached to the inner cabinet to reduce noise.

This door latch secures the dishwasher door and signals the control board when closed, allowing the cycle to begin. If the door won’t latch or the dishwasher won’t start, the latch may be faulty. Comp...

This dishwasher door spring is sold individually. It is recommended if you are replacing one side, to replace both.

This is a multi-use cover screw. It fits appliances such as dryers, ranges, washers, dishwashers, refrigerators, air conditioners, washer dryer combos, freezers, wall ovens, microwaves, dehumidifiers,...

Sold individually.

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

This part is used to drain water from your dishwasher.