66515822692 Kenmore Dishwasher - Instructions

put new seal in and it still leaked!hum

Came home and my husband had it all done. He said it was simple and it looks bran new again. Very satisfied.

Opened the door by using a star screwdriver. Pulled the door inside from the outside. Located the broken spring, put in new one (be very carefull to see how the insides are put together..makes life ALOT easier), and carefully put back together.

dropped the new float in, works like a charm

The part arrived the next day with regular postage, outstanding service.

easy to remove the old gasket but did not solve the problem door leaks from the bottom and water remains on bottom of machine

Opened the door removed old seal and put the new one in. The only hard part was getting the new seal out of the package. It took about 1 minute to do. Very easy.

Amazing how quickly the part was shipped and arrived. Very easy to install no tools needed.very pleased with everything . Thank you.

removed old rack and replaced with the new.

pulled out the old seal and put in the new, fixed the leak!

Watched the video and did the repair it was easy.

I am a 64 year old female and replacing the broken Access Panel was fairly easy for me to do without help. The hardest part was separating the metal bottom part from the broken plastic part in the old access panel. I had to break the plastic away from the metal section using pliars. That took me almost 10 minutes. Slip the decorative plastic facing out of the old piece and into the new one. Attaching the metal piece into the new panel was a "snap". The bottom screws do not need to be removed. Just loosen a bit and slide the new unit onto them. Then using a nut driver screw in the two top screws and then tighten the two lower screws. Now the unit looks like new.

Pulled out old gasket with needle nosed pliers, cleaned groove, installed new gasket just like the video provided on website. Took less than 10 minutes.

Watched your video and replaced seal in approx. 5 minutes, probably less. Still leaked so I looked at your page for solutions, found out where the air vent was and pried it open, very disgusting mess. With screw driver and long tweezers dug out what I could then poured a mixture of bleach and water in the vent. Totally cleaned it, very white, vent cover went into a bucket of bleach and hot water and it cleaned very well. Put vent cover back on and did a load of dishes, works fine. Thank you for having such a great website, if I ever need help again I will be back. It's a shame someone didn't tell you about cleaning the air vent when you bought the dishwasher.

Replaced the door gasket and float and switch - no improvement. Still leaking about 1 quart water per load. Hmmmmm. Took the lower arm off and discovered a screw missing and the impeller gasket below lower arm was bad. It is a gasket about 4 inchs in diameter, it was stetched and torn. The missing gasket was allowing water to shoot across the wash water like Moses parting the Rea Sea. Wave water was going up the float (and out) and up the lower door gasket (and out). Ordered the screw and the "rubber band" gasket. Took about five minutes to drop / screw them in. Several other screws were backed out part way. Now the floor is completely dry. Dishwasher is fixed. Wife is happy. I saved $1200 on the new dishwasher she does not need. In addition, the water squirt out of the pump impeller cover was lowering the water pressure in both arms. Now the dishes are dramatically cleaner and better scrubbed than they have been for the last couple years. Glasses sparkle again. Thanks PartsSelect for the diagrams and instructions. Allen.