Models > DU471 > Instructions

DU471 Jenn-Air Dishwasher - Instructions

Jump to:

All Instructions for the DU471
106 - 120 of 125
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Hugh from Avon, MN
Parts Used:
6-9021150
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
The dishwasher did not drain
"The order arrived in relatively short order. However, the installation must have been hilarious to any observer. Imagiine an arthritic septuagenerian getting down on the floor and wallowing about fitting a dish washer belt. Hints: 1. Grasp the pulley on the pump with your left hand from under the discharge hose (more room than over the hose) when fitting the belt to the rear of that pulley. 2. Use a hot pad (not an emroidered & quilted one reserved for company) to protect your L forearm from the frame member on the bottom of the machine. Getting up was worse than getting down, but it works! In dishwasher years it's much older than I am."
Was this instruction helpful to you?
Thank you for voting!
Customer:
JOHN from SLIDELL, LA
Parts Used:
WP901403
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
water leaking at door of dishwasher
based on instructions from previous customers, took off front control and door panel, removed old gasket, replaced new gasket by aligning tabs and pulling through with needle nose pliers, leaking stopped
Was this instruction helpful to you?
Thank you for voting!
Customer:
John from Los Alamos, NM
Parts Used:
6-9021150
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver
Belt to stiff to roll onto pulley
150 degrees for ten minutes provided enough flexibility to allow the belt to be rolled around the pulley. The machine has been used successfully since installation.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Donald from Lake City, MN
Parts Used:
6-9021150
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Socket set
would not drain
The part was a bit difficult to put on and then I discovered that it still would not drain. It turned out that my drain hose was plugged
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ed from North East, MD
Parts Used:
WPW10254672
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Faucet adapter leaked
Replaced the faucet adapter, works fine
Was this instruction helpful to you?
Thank you for voting!
Customer:
George from Cameron, NC
Parts Used:
WPW10254672
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
changed out kitchen sink faucet set
replaced the faucet adapter I did not save when I change out the kitchen sink faucet set
Was this instruction helpful to you?
Thank you for voting!
Customer:
Roger from Saganaw, MI
Parts Used:
911594
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Nipple that upper spray arm goes on.
Maytag dealer said the part was unavailable but there I sat looking at it.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the DU471
106 - 120 of 125