HDA2100N10WW Hotpoint Dishwasher - Instructions

First I removed the rail end caps on both sides of the rack with a screw driver. I removed the old roller slides and stud rollers. Then I easily snapped the roller slide in the roller stud and put it back on the slide. Placed the rail end caps. Done! All in 5 minutes.

The finished accent panel on my GE dishwasher was dented and looked awful in my newly remodeled kitchen. I thought about purchasing a new dishwasher but instead searched the web for the part. Found Parts select and it was so easy to compare my part with the graph picture provided. Just count off the boxes for measurement and you will know if you selected the part you need. Access panel arrived in two days,packaged well, and I am happy to have found this website. Give it a try....and returns are easy too if you make a mistake in ordering. My order was perfect on the firt try.

I thought the parts wouldn't be aailable. 10 minutes on the interner, easy check out, arrived UPS next day, popped off the old wheels according to the diagram and popped the new ones on.

Used diag wire cutters to remove temporary cable tie that I installed to make temp repair. Positioned redesigned GE OEM wheel axle on tray, snapped in place. Walked away after abt 1 min repair job.

All new seals

Very easy! Removed 4 screws that was holding the valve to the bracket. Placed bracket over water inlet line. Attached copper threaded coupling with pliers.Screwed valved on to the coupling. Attached bracket to the valve with 4 screws. Reattached water line. Attached bracket to frame of dishwaser. Put kickplate back on and done!

Simply replace wheel

so easy! Ordered the rollers and clips ... popped them on and done!!!

i needed new rollers and inserts to keep wheels on now its like new when i pull out bottom basket

I opened the dishwasher, rolled out the defective/rusty Dishrack, removed it from the dishwasher and replaced it with the new Lower Dishwasher Dishrack.

Before attempting this repair, remember to remove any dishes from the lower Dishwasher Dishrack.

replaced new wheels

Ordered pump mechanism and replaced defective pump. A very easy replacement

removed the rack and snapped the 4 week/axle assemblies on rack by hand pressure returned rack to track.

First, remove the bottom front covers (two parts four screws). Second, remove the two screws at the top that secure the dishwasher to the counter. Third, gently pull away the dishwasher from underneath the counter just far enough to see and be able to remove the door spring(s) - one on each side. Fourth, remove the existing hinge arm link(s) if not already broken off, replace with the new one(s). Note that the door hinge goes on the door (front) side of the spring and the other side fits into a groove on the door arm - the other end of the spring attaches to one of the 3 available holes on the frame at the bottom. It would be a good idea to replace the hinge arm links on both sides even if only one is broken. Make sure that the door has the right tension (each spring can be hooked in 1 of 3 holes to adjust the tension). Then gently push the dishwasher back under the counter. Finally, replace the screws under the counter and replace the covers on the bottom front. All of this should take no more than 15-20 minutes. This was an easy job!

just snapped the new part in. couldn't have been easier