GDB742RJS1 Gibson Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- thomas from Neptune, NJ
- Parts Used:
- 154637401
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers, Wrench set
No water comming into dishwasher.
Cheked supply water line, water there but not getting into machine.Removed screws that hold machine to counter top, lowered adjustable legs and disconnected water line. I turned off power for safety.Pulled machine out about 8 inches to access water valve from the side. disconnect power supply wires, and water discharge hose, remove two screws on valve bracket. Install new valve and reconnect.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Brian from Weaverville, NC
- Parts Used:
- 5304517203
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The lower spray arm became loose and melted on the heater.
Very simple to repair, cleaned the melted plastic from the heater, received the part within 2 days and pushed the new arm into the 2 bracket clamps and it was done. Since this was an older unit they told me the replaceable part number and the price was very reasonable..less then $30 for the whole job!
Was this instruction helpful to you?
Thank you for voting!
door leak
Pulled out old gasket and replaced with a new one.New gasket snapped right in place in bottom of door,
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bradley from Pine Grove, PA
- Parts Used:
- 154637401
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers, Wrench (Adjustable)
Water inlet valve failed and leaked.
Turn off water supply to dishwasher. Turn off electrical power to dishwasher. Remove lower front cover to expose underneath the unit. Locate the valve toward the left, front underneath the washer. unplug the wire harness from the valve. lay a towel under the valve to catch water that WILL come out. Using a pair of needle nose pliers, squeeze and slide back the hose clamp holding the hose to the water bottle. Remove the 2 screws that mount the valve bracket to the frame. There is plenty of slack in the braided water feed hose to pull the valve out from under the washer. Remove the hose from the fitting and then remove the fitting from the valve. Re-wrap the threads of the fitting with teflon tape and install into new valve. Attach and tighten the braided supply hose to the fitting. Install the valve in reverse order of removal. It takes about 10 minutes to do.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tina from Manassas, VA
- Parts Used:
- 5304517203
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The lower spray arm feel onto the heating element and melted a hughe hole, which caused my dishwasher to leak water from under the front door. Alos, it didn't clean dishes well at all.
all I did was replace the arm , however I took advice from another PartSelect customer - I had to screw the arm into the floor of the dishwasher until it clicked!! Now, it will not tip over.
Was this instruction helpful to you?
Thank you for voting!