GDB755RJS2 Gibson Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Water leading from bottom of door
Just like the instruction video. I pulled the old gaskets out, cleaned the gunk that had accumulated and put the new gaskets in. The tub gasket does not require any cutting or stretching. Just make sure it makes the turn at the bottom of the tub so the door seals properly. The door gasket was very simple to replace.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sandra from Wilton, NH
- Parts Used:
- 5304517203
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Spray arm was melted on end from heating element in bottom of unit. Dishes were not being cleaned well.
Replaced arm - SO easy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Brandie from Summerville, SC
- Parts Used:
- 5304517203
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The dishwasher was "broken" and it needed to be replaced...
When I looked at my prospective home for the first time, the current "month to month" renters made sure to tell me EVERYTHING that was wrong with the place. One of those things was that the dishwasher was broken and beyond repair. Upon moving in, my brother in law asked "Did you try turning it on??" We did, it worked and drained...so why was it "broken?" The lower spray arm kept popping out mid cycle, then would get melted on the heating units at the bottom of the unit during the drying process. I easily found and purchased the part from this site. Once it got here, I literally just had to pop it on, no tools, no mess. Fixed!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- thomas from Neptune, NJ
- Parts Used:
- 154637401
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers, Wrench set
No water comming into dishwasher.
Cheked supply water line, water there but not getting into machine.Removed screws that hold machine to counter top, lowered adjustable legs and disconnected water line. I turned off power for safety.Pulled machine out about 8 inches to access water valve from the side. disconnect power supply wires, and water discharge hose, remove two screws on valve bracket. Install new valve and reconnect.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Brian from Weaverville, NC
- Parts Used:
- 5304517203
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The lower spray arm became loose and melted on the heater.
Very simple to repair, cleaned the melted plastic from the heater, received the part within 2 days and pushed the new arm into the 2 bracket clamps and it was done. Since this was an older unit they told me the replaceable part number and the price was very reasonable..less then $30 for the whole job!
Was this instruction helpful to you?
Thank you for voting!