Models > PDW9200J00WW > Instructions

PDW9200J00WW General Electric Dishwasher - Instructions

Jump to:

All Instructions for the PDW9200J00WW
91 - 105 of 428
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Chris from Medina, MN
Parts Used:
WD35X21041, WD35X21041
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Original wheels kept falling off, rack would go off track and it drove me crazy
Simple, took five minutes, no tools, problem solved.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michelle from Spokane Valley, WA
Parts Used:
WD35X21041, WD35X21041
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
The plastic wheels kept falling off the bottom rack of the dishwasher
The old wheels and attachment brackets were easily removed since they were always falling off. I ordered all new brackets and wheels, but it turns out I didn't need new wheels. If your original wheels are in good condition, they are the same size as the new ones and fit the new brackets. The new attachment brackets are built differently than the ones that came with the dishwasher, but (a good thing considering the originals only lasted 1 1/2 years). The new brackets and wheels snapped together and snapped into place on the dishwasher in minutes--no tools were needed. It took longer to cut the parts out of the packaging than to install them. The bottom rack now rolls out like it did when it was brand new. Definitely worth the few dollars in parts.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Suzanne from CHEYENNE, WY
Parts Used:
WD12X10109, WD12X10061
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Old parts showing wear
Watched a YouTube video on disassembly, parts replacement, and reassembly.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jonni from VACAVILLE, CA
Parts Used:
WD28X25960
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
leg fell off of bottom rack.
Slid it in. Very easy and the replacement part is built better than the original part.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
John C from SPRINGFIELD, VA
Parts Used:
WD28X25960
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Bottom dishwasher rack rusted out
Simple install- just roll it in. Fit perfect. Better design than OEM part. Perfect.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Amelia from PEORIA, IL
Parts Used:
WD28X25960
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Rack was rusted and broken.
It was a very simple replacement. I took the old one out and rolled the new one in. It took less than 5 minutes!
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Wayne from SEASIDE, OR
Parts Used:
WD35X21041
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Older wheels had broken clips.
Simply remove broken wheels and clip on replacements. No tools are necessary for this fix and the replacement was inexpensive and easy to install. The kit worked beautifully.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
KEVIN from MACKINAW, IL
Parts Used:
WD12X10163
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
The detergent dispenser latch was broken
The repair was easy. Removed all the screws from the inside door panel, approx. 11. Watch out for that last screw as there isn't anything else holding the outside panel, inside panel and control panel together other than those screws. I then unplugged the old dispenser backed out another 6 screws and replaced the old dispenser with the new one. Put it all back together within about a half hour.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Joseph from Tucson, AZ
Parts Used:
WD35X21041, WD19X10032
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
I'm told I had a typical pump seal leak.
I unplugged and removed my dishwasher and followed the instructions extactly repairing the pump and replacing the parts I had just received. I torgued the ring to the specified amount, installed the pump and found the impeller could not turn. I dis-assembled it all again and loosened the ring to allow the impeller to turn, reinstalled it and when I initiated the wash cycle, water began running wildly. Next step, replace motor and pump as the pump motor shaft has gone out
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Janice from Rockville, MO
Parts Used:
WD24X10014
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Couldn't drain water
I connected one end of hose to the drain using a hose clamp and screwdriver then connected the other end to the dishwasher using anouther hose clamp and a screwdriver..
4 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jim from Palatka, FL
Parts Used:
WD28X25960
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Old rack was rusted out and missing most of the wheels.
Easiest repair ever. My new rack arrived in three days, opened the box and slid it in. Better quality than the original. Excellent service!
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
sean from oakland gardenns, NY
Parts Used:
WD35X21041
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
clips on wheeles were broken
replaced clips that were much better made.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Paul from Oakland, NJ
Parts Used:
WD35X21036
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
worn wheels on upper rack
parts were easy to find and the repair was a breeze. Thanks for your help.
4 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michelle from Carlisle, PA
Parts Used:
WD12X10163
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Detergent cap would not stay closed
After removing the screws, the front of the dishwasher easily came off. I put 2 screws back in to hold the control panel in place. I did not want that to dangle while replacing the part. The part came off easily after removing the screws. Everything went together easy.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Eric from Raleigh, NC
Parts Used:
WD35X21041
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
wheel fel off bottom tray
but axle on new wheen and put axle on tray
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the PDW9200J00WW
91 - 105 of 428