Models > GSM1860F00SS > Instructions

GSM1860F00SS General Electric Dishwasher - Instructions

Jump to:

All Instructions for the GSM1860F00SS
1 - 15 of 38
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Greg from Doon, IA
Parts Used:
WD12X10122
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
cap was melted
replaced it
17 of 18 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Dean from Newark, NY
Parts Used:
WD12X10174, WD01X10207
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
soap dispenser latch was worn - cover would not stay shut
remove door panel (outer side) remove wires from soap dispenser remove old dispenser install new dispenser re-install wires and door cover total time less than 30 minutes
11 of 16 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Pauline from Oceanside, CA
Parts Used:
WD28X10215
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Silverware basket had holes in it.
Took old one out and replaced new one in less than one minute.

Very easy and easy to order also.
6 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jerome from Arlington, VA
Parts Used:
WD12X10122
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Lost Rinse Aid cap
Inserted new cap purchased from PartSelect.
7 of 14 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Larry from Denvr, CO
Parts Used:
WD12X10122
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Dispenser Cap Missing
Ordered new cap and put it on when it arrived.
Simple
4 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Alice from BLAINE, MN
Parts Used:
WD12X10122
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
cap had melted mi
Unscrew the old one and screw in the new one.
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
George from Gregory, MI
Parts Used:
WD28X10215
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Bottom of basket deteriorated
Remove old basket, discard, place new basket in dishwasher, fill with dirty silverware, run wash cycle.
3 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Andre from Ventura, CA
Parts Used:
WD28X10215, WD01X10242
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Dishwasher didn't clean well. Silverware basket was damaged.
Just removed the old ring nut by hand and replaced it with the new one. Took me one minute.
Exchanged the silverware basket.
3 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jean from White Plains, NY
Parts Used:
WD12X10122
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
missing cap
I placed the missing cap into the dispenser.
3 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Tom from Brooklyn, NY
Parts Used:
WD01X10242, WD08X23648
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Wrench (Adjustable)
Leaking from top of main conduit
Note: I also purchased the main conduit part (PartSelect #: PS958967).

My repair is pretty much the same as the previous poster from TX. The RING NUT W/GASKET part seems to wear easily on this GE dishwasher.

Disconnected dishwasher from electrical. You have to remove the rear lower brace panel in order to remove the main conduit. The bottom end of the main conduit is clamped to a hose.

Installed the new main conduit and o-ring, screwed RING NUT W/GASKET onto upper end of main conduit. I tightened the ring nut with the wrench to make sure I got a good seal without over tightening.

I had to use a new hose clamp to reattach the lower end of the main conduit.

Reinstalled brace panel, reconnected electric, and tested.

It was an easy fix, the parts did not cost too much. I'm glad I fixed it rather than paying some repairman $$. I purchased an extra RING NUT W/GASKET in case it deteriorates again.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Duane from Springfield, MO
Parts Used:
WD01X10242
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
top washer arm performing poorly
removed top rack which contains washer arm.
unscrewed the old ringnut which had lost its gasket, that the top rack washer arm merges with.
screwed the new ring nut onto the threads of the pipe which protrudes thru the back inside if the machine. reinstalled the top rack .
job done.
3 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Deborah from Los Osos, CA
Parts Used:
WD28X10215
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
holes in dishwasher silverware basket
removed old basket, put new one in
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
ANDY from SHELBY, OH
Parts Used:
WD12X10164, WD01X10242, WD08X23648
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers, Wrench set
Water Leak
Replaced main conduit, o ring,and ring nut with gasket.
3 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
John from ANN ARBOR, MI
Parts Used:
WD28X10215
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
The basket handle was broken in transit.
I ordered the silverware basket because the original started to separate. The shipment box was damaged and sure enough the handle was broken. The handle can be removed so I replaced the new handle with the old handle, since it was the basket that really needed. Pops off very easily.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
john from TORONTO, OH
Parts Used:
WD31X10074
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers, Wrench set
door gasket bad, door deformed
removed inner panel, removed soap dispenser installtion was straight forward 45 min time install
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GSM1860F00SS
1 - 15 of 38