Models > GSD3300K00CC > Instructions

GSD3300K00CC General Electric Dishwasher - Instructions

Jump to:

All Instructions for the GSD3300K00CC
46 - 60 of 216
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Nelson from Oroville, CA
Parts Used:
WD28X31819
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Disrack was getting rusty
Removed old rack replaced with new one which was an exact duplicate. Mama's happy; everybody's happy.
4 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Tom from UPPR CHICHSTR, PA
Parts Used:
WD35X21038
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Wheel had melted and support cracked
Removed the lower rack and installed new wheels with clips
5 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lawrence from ROLESVILLE, NC
Parts Used:
WD21X10261
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
dishwasher did not start
Took out interlock switch (two leads) and replaced with new one. As simple as that.
7 of 13 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Asok from HELOTES, TX
Parts Used:
WD35X21038
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Three of the 8 wheels broke.
The newly purchased wheels have a little different design and could be installed in a matter of few seconds.
5 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Eduardo J from San Angelo, TX
Parts Used:
WD28X31820, WD28X31819
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Rusted Racks
Replaced lower rack with new. Upper rack removed front stoppers, removed old rack, slit new rack in and replaced stoppers. Total time about 15 mins.
4 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Helen from Carol Stream, IL
Parts Used:
WD12X10284
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Rinse Aid Fill Cap melted because it landed next to the heating element because it wasn't screwed in
Simply screwed in new cap
4 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from Colleyville, TX
Parts Used:
WD08X10057
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Dishwasher leaked
Plumber had suggested trying a new gasket rather than replace the dishwasher. Ordered one and installed it. Cleaned door and installed gasket in about 30 minutes. So far it works great .... and ... cheaper than new dishwasher.
4 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Sharon from THE VILLAGES, FL
Parts Used:
WD35X21038
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
The wheels on the lower rack of our dishwasher kept falling off.
Removed the lower rack. Took off the old wheels. Put the axles on the new wheels which took a little manpower, but became easier once you did a couple (there are 8 wheels). Then snapped the new wheels on the rack which was really simple. The new design is much improved to the old one. The wheels glide better, then they ever did. We're sorry we didn't think of this repair years ago and the cost was a fraction of the cost of a new dishwasher.
4 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jeffery from DOUBLE SPGS, AL
Parts Used:
WD22X10055
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Socket set, Wrench set
The telescopic part of the washer was broken.
The part came in as ordered. After removing the dish rack, I loosened three 1/4" screws (two on the strainer basket and one at the base of the spray arm. I had to slide the rubber hose down and back to disconnect the base which I did by turning counter clockwise. The new one went in by reversing what I just described. Other than two of the screws being difficult to reach, everything worked fine.Thanks for your site.
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Harry from SAINT LOUIS, MO
Parts Used:
WD12X10284
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
New home to me. Part lost
Put on a new cap.
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
John from Yuma, AZ
Parts Used:
WD28X31819
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
wornout rack
I took out the old one and put the new one in.
4 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from Hillsborough, NC
Parts Used:
WD28X31819
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Put lower rack in
Took old rack out put new rack
4 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Rhonda from CANTON, GA
Parts Used:
WD13X10003
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Latch was broken so dishwasher wouldn't run
I watched several YouTube videos on how to make the repair. It looked very easy but sometimes professionals, because they've done it before, don't point out small tips that would help a DIY homeowner. The latch goes easily into the inner door slot but there's nothing to hold it there. The videos show the inner and outer door being closed together without showing that you have to hold the latch in place while bringing the outer door up to meet the inner door. Any movement of the inner door makes the latch fall out. So I would say it took me 5 times longer to do this repair than it would if I was doing it again.
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Denise from PALERMO, ME
Parts Used:
WD35X21038
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Missing wheels
The wheel kit came with axel's to support them. They snapped in place in seconds. No instructions provided, but installing method was obvious.
4 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ralph from McMinnville, OR
Parts Used:
WD12X10284
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Damaged rinse agent dispenser
Unscrewed old one and installed the new one.
7 of 15 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GSD3300K00CC
46 - 60 of 216