GLD2800V00WW General Electric Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Nick from Chatham, NJ
- Parts Used:
- WD35X21038
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
wheels colapsed
replaced new wheels
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- william from sykesville, MD
- Parts Used:
- WD18X10010, WD18X10008
- Difficulty Level:
- Really Easy
- Total Repair Time:
- More than 2 hours
- Tools:
- Socket set
water leaking from sump
I had a slow leak from vicinity of sump. I replaced sump and pump connector as these were only likely sources of leak based on parts select history. Turns out plastic tub had a fine crack. The crack was directly under the heating element which had melted the plastic and over time created this small crack that was found by a repair guy immediately. I even suspected a tub leak and searched for one but being directly under the element made it invisible to me and in an area I did not suspect (front). Oh well - also learned GE charges $100. to come to my house, show me a crack, and leave (I repaired it with epoxy).
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ROY from CULPEPER, VA
- Parts Used:
- WD13X10045
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
broken door handle actuator
Parts were easy to find, easy to order and arrived prior to the advertised delivery date. Instructions for replacement were easy to understand and in about 10 minutes the old part was removed, and the new one installed. thanks for your prompt and efficient company.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Frank from Tinton Falls, NJ
- Parts Used:
- WD22X10029
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
The old plastic filter's corner were bent up allow food to get into the plumbing going to the articulation sprayers and clogging them.
Remove bottom articulating sprayer and water fittings. Remove and replace filter
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Erin K. from Las Vegas, NV
- Parts Used:
- WD12X10163
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
soap dispenser was not staying closed....
hubby had no prob replacing the new part!!YEA!!dishes are clean again!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Linda from Tucson, AZ
- Parts Used:
- WD12X10278, WD35X21038
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
bottom rack f dishwasher wheels fell off at every use
I ordered both new wheels and stud that goes in the centers of each wheel. It took longer to cut the bags open than to install them. Works like a dream and no sqeaking and dishwasher works better since it is the correct distance from the water rotation arm on the bottom of the washer! Wonderful experience by an all thumbs do it yourselfer!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nicholas from Alexandria, VA
- Parts Used:
- WD35X21038, WD35X21038
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
lost wheel
just snapped the new part in. couldn't have been easier
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Russell from Rosharon, TX
- Parts Used:
- WD02X10169, WD02X10067
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
missing screw for Spray Arm
Remove top rack stops, slide out upper rack from rack railing, turn over upper rack and attach spray arm using spray arm bearing and screw. Reassemble in reverse order.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Christopher from St Augustine, FL
- Parts Used:
- WD24X10045, WD12X10061, WD01X10103
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
Rate chewed drain hose up.
Removed screws that held dishwasher under cabinet...pulled out DW...removed old part...replaced with new....easier than falling off a stump.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cerem from Staten Island, NY
- Parts Used:
- WD13X10045
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
There was no problem in installing this part
Easily screwed on this part and used it for the door of the dishwasher to properly open and close
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- norma from edgewater, MD
- Parts Used:
- WD08X10018
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
linking
im 73 years old and a lady did it myself very easy
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William from Henrico, VA
- Parts Used:
- WD13X10045
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
The latch on our dishwasher broke
I unscrewed all the screws from the inside of the dishwaher door. I took out the broken part, installed the new parts and screwed the screws back in. Part Select was wonderful to work with and the parts arrived the day after they were ordered.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Ocala, FL
- Parts Used:
- WD12X10163
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Detergent dispenser would not latch
Repairs do not get any easier than this. Remove 12 screws to disassemble door panel (be careful not to let front panel of assembly to drop or bend when screws release it). Remove 6 screws to remove old detergent dispenser. Unplug cable from old dispenser. Connect cable to new dispenser. Install new dispenser into door with 6 screws and then reassemble door panel with 12 screws making sure to keep all wiring free from pressure points.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Claude from Orem, UT
- Parts Used:
- WD12X10278, WD35X21038
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Six of the eight wheels were gone from the lower rack.
We pulled off the remaining two wheels and noted how they were attached. Then we assembled the wheel/axle assemblies and clipped them on. We hardly used any tools at all -- mostly to rip open the plastic bags containing the parts. The entire repair was probably 20 minutes and the rack works great.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- andrew from galveston, TX
- Parts Used:
- WD21X10224
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
wouldnt start and lights flickered
pulled switches flicked leaver worked when itwanted to and not every time. I removed then shorted then rechecked everthing worked. got on line ordered parts good price fast service fixed 30 min when they came in saved money.Thank God! 20.00 fix instead of 200.00 +
Was this instruction helpful to you?
Thank you for voting!