Models > GLD4550R10CS > Instructions

GLD4550R10CS General Electric Dishwasher - Instructions

Jump to:

All Instructions for the GLD4550R10CS
91 - 105 of 334
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Michelle from Carlisle, PA
Parts Used:
WD12X10163
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Detergent cap would not stay closed
After removing the screws, the front of the dishwasher easily came off. I put 2 screws back in to hold the control panel in place. I did not want that to dangle while replacing the part. The part came off easily after removing the screws. Everything went together easy.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kimberly from Durango, CO
Parts Used:
WD12X10278, WD35X21038
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
some wheels had broken, was really hard to move rack in and out.
I am NOT handy, but my husband was gone when the wheels and stud/axles came. I was able to replace all of them in about ten minutes with no tools. Easy and no more frustrations!!!!!
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Estelle from Queen Creek, AZ
Parts Used:
WD08X10018
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
We had a rip in our tub gasket.
I removed the old seal, cleaned behind it, and then put the new seal in. We saw a video on You Tube on how to do it. Partselect also sent instructions on a e mail with the order receipt. We enjoyed working with you guys. Your customer service representative was very nice and accurate in sending out the part. All went as she said it would. Thanks!!
3 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Gail from Woodstock, GA
Parts Used:
WD12X10278
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
axle for wheel was broken
Popped the axle on to the wheel, then snapped it on to the lower drawer - done!
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
ILONA from AUSTIN, TX
Parts Used:
WD12X10278, WD35X21038
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
one wheel was missing, others kept on falling off
Just snapped studs and wheels together and put them into place.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Gary from HAVERHILL, MA
Parts Used:
WD15X10014
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)
Leaking valve
Used teflon tape around new 3/8 elbow. Re-installed valve in originals postion. Connected supply hose and reconnected electrical to valve.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
KENNETH from WAPPINGERS FALLS, NY
Parts Used:
WD27X10219
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
missing toekick
two screws, two minutes, all done
3 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
LELAH from LANSING, MI
Parts Used:
WD35X21035
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
The wheels on the upper basket had broken
I removed the plastic end caps by gently pushing and twisting them. Once the end caps were off the basket slid out. The old wheels were removed and the new ones clipped in very easily. I then slid the basket back into place and replaced the end caps. The most difficult part was removing the end caps. I was afraid that I would break them, but by being careful and not forcing the piece they easily came off.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
donna from walworth, NY
Parts Used:
WD12X10304
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
upper dishwashr rack lost the end cap and the rack kept coming off the track when you went to push it back in it would jam into the track and all the dishes would bang and fall.
placed the end cap into location and forced it into place. Fixed -and we are all much happier!!
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michele from NEOLA, UT
Parts Used:
WD13X10066
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
its wasn't latching so the dishwasher wouldn't work unless i held the door in the whole time
I called your tech and she sent me a awesome video that made it so easy to fix on my own
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Alan from MECHANICSVLLE, VA
Parts Used:
WD28X10177
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Broken silverware basket
Pulled the old one out and placed the new one right into place
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Eric from SIMPSONVILLE, SC
Parts Used:
WD12X10163
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
The door on dishwasher soap dispenser broke.
Repaired the soap dispenser.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from WALNUT CREEK, CA
Parts Used:
WD12X10278
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
Broken axle which hold wheel on lower rack
Easy install, snap in new axle and put wheel on stud. Be sure to check all wheels for any replacement due to heat melting wheels on rack.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
john from SOUTHPORT, NC
Parts Used:
WD12X10304
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
rack slide end cap broke
Slide it into the arm until you hear it snap
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Cindy from Davidson, NC
Parts Used:
WD12X10304
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Cap had broken off the top rack, it kept sliding down
I just had to play around with it to attach the new cap without breaking it.....never did this before but eureka! it worked.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GLD4550R10CS
91 - 105 of 334