Models > GDT226SGL1BB > Instructions

GDT226SGL1BB General Electric Dishwasher - Instructions

Jump to:

All Instructions for the GDT226SGL1BB
1 - 2 of 2
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Al from REDDING, CA
Parts Used:
WD01X24739, WD01X24738
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
While the dishwasher door was fully open, someone accidentally turned and tripped over it with much of their weight. Now the door won't fully close.
*UNPLUG THE DISHWASHER
*remove 2 mounting screws attatching dishwasher to underside of countertop.
*with the dishwasher door closed, remove left and right side hinge cables off pulley and hinge.
*fully open door and remove all perimeter screws except for 2 screws holding the latch assembly.
*carefully separate outer door shell from door body.
*disconnect electrical clip from inside top of outer shell. Carefully set outer shell aside.
*each hinge has 2 Torx head screws and 2 Phillips head screws, remove these. You can now slide the door body out and away from the hinges and dishwasher.
*these hinges were slightly bent so I had to use a ball peen hammer to tap them off the post.
To reassemble, reverse these instructions.
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Richard from SEELEY LAKE, MT
Parts Used:
WD22X25158
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Upper basket sprayer was falling off under pressure.
Replaced the sprayer with new. Very easy repair.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GDT226SGL1BB
1 - 2 of 2