GHDA676NS General Electric Dishwasher - Instructions

problem solved..thanks

so easy! Ordered the rollers and clips ... popped them on and done!!!

i needed new rollers and inserts to keep wheels on now its like new when i pull out bottom basket

Simply replace wheel

I replaced the entire Water Inlet Valve. The part was perfect and fixed the problem. The only difficulty was the brass elbow connection that connects to the incoming water line had plumbing putting that connected it to the old Water Inlet Valve. I had to get a couple of large adjustable wrenches to take it off. I needed it as I didn't want to buy another one. I was thankful that I had some extra plumbing putty on hand to seal the threads when I put the brass elbow back on the new Water Inlet Valve. That saved me a trip to the hardware story. All in all, I'm very pleased that I was able to fix this myself. I'm not exactly a Mr. Fixit, so this was a good experience.

I removed the old valve with wrench and Philips screw driver.Unscrewed the mounting plate and water hose. When I went to replace the new water inlet valve, I found that there was a mismatch on the screw holes for the new mounting plate. Different screw threads. I tried to find screws that would fit, but didn't have any.So I manged to make the old screws re-thread themselves and hold the plate in place. I then attached the water hose and started the dishwasher up. Make sure to power off the unit then power it back on to clear and reset the programming. Works great now.

replaced new wheels

Self

removed the rack and snapped the 4 week/axle assemblies on rack by hand pressure returned rack to track.

First I removed the 8 screws on the interior side of the door that holds the plastic inner-face to the door assembly. This allowed me to easily pry the inner face away from the outer face which exposed the latch assembly.

The broken latch practically fell out making it very easy to work the new one into place.

I replaced the 8 screws, closed the door until I heard it latch and then squeezed the handle and was rewarded with a very satisfying sound and feel as the door popped open without a hitch.

I know a repairman would have cost me a minimum of $75 plus a hefty price for the part.

just snapped the new part in. couldn't have been easier

Parts were easy to find, easy to order and arrived prior to the advertised delivery date. Instructions for replacement were easy to understand and in about 10 minutes the old part was removed, and the new one installed. thanks for your prompt and efficient company.

I had a slow leak from vicinity of sump. I replaced sump and pump connector as these were only likely sources of leak based on parts select history. Turns out plastic tub had a fine crack. The crack was directly under the heating element which had melted the plastic and over time created this small crack that was found by a repair guy immediately. I even suspected a tub leak and searched for one but being directly under the element made it invisible to me and in an area I did not suspect (front). Oh well - also learned GE charges $100. to come to my house, show me a crack, and leave (I repaired it with epoxy).

Remove bottom articulating sprayer and water fittings. Remove and replace filter

Removed top screws to allow the ability to remove control dishwasher control unit. Remove door parts & be careful how you remove them & put back the door parts the same way.