Models > PDW8800LB > Instructions

PDW8800LB General Electric Dishwasher - Instructions

Jump to:

All Instructions for the PDW8800LB
121 - 135 of 482
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
David from Norwell, MA
Parts Used:
WD24X10045, WD01X10279
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers, Wrench (Adjustable)
New install missing drain tube and clamp.
Purchased new $1400 dishwasher from sales floor for $699. Cosmetically perfect, but missing drain tube and clamp. Seemed like a good deal... and it was. Needed parts were $34. Install of this machine was a breeze, and it is suoer quiet...I need to get down on the floor and listen for water flow to know that it's working. Really.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Monte from Fairfax, VA
Parts Used:
WD35X21041, WD12X10262, WD35X21041
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Roller melted from heating coil
Installed new roller which where larger than the original rollers. I believe these larger rollers will stop rack from slipping down near heating coils.
The new rollers snapped on with very litlle effort.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Eric from SIMPSONVILLE, SC
Parts Used:
WD12X10163
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
The door on dishwasher soap dispenser broke.
Repaired the soap dispenser.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Samuel from LAS VEGAS, NV
Parts Used:
WD14X10009
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
Hinge arm link wore out
Used Phillips screwdriver to undo brackets that keep dishwasher in place. Pulled out dishwasher from underneath the counter. Placed hinge arm in spring, hooked spring onto clip, placed hinge arm in clip. Put back dishwasher under the counter and screwed in place. Took all of 15 minutes. Saved 185.00 for service call.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jack D from CLEBURNE, TX
Parts Used:
WD22X10047
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Heat shield on lower spray arm came loose and blocked spray arm from turning
Followed instructions on how-to video on website on how to remove and replace lower spray arm.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
James from FAIRFIELD, CT
Parts Used:
WD28X24469
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Holes in old dishwasher basket
The replacement dishwasher basket easily fit in my dishwasher. Easy to order. Quick delivery. Highly recommended.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Bob from Chandler, AZ
Parts Used:
WD28X25960
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Due the the age of this dishwasher (13 years) both upper and lower racks were showing significant rusting.
This lower rack (GE part #WD28X25960) was ready to roll right into the dishwasher straight out of the box, no tools needed.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Thomas from TAMPA, FL
Parts Used:
WD35X21041
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Old rollers broken
No instructions. At first thought I needed instructions. A minute later I was attaching the new rollers. Simple and easy. Took less than 15 minutes. Would recommend these rollers.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ron from TYNGSBORO, MA
Parts Used:
WD08X10032
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Started to have a leak
Pull out the old, died gasket. Clean out track that holds gasket. insert new gasket.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Prasad from LEAWOOD, KS
Parts Used:
WD21X10169
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers, Socket set
Dishwasher was not starting
Replaced interlock assembly as one of the possible causes. The replacement was easy, but this was not the final fix. I also replaced the water inlet valve, flood switch and finally found that there was large calcification within the drain tube assembly (not visible, but was blocking water). Got a new flexible tubing and new drain hose, plugged everything together and the dishwasher runs like new now. Watching for a potential leak from the drain tube to drain hose connection and mya need to tape it up, but so far so good...
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
M Anne from VIENNA, VA
Parts Used:
WD22X10047
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
Our dishwasher lower arm had become clogged
HAHA! The easiest repair we have ever done! Took it out of the box, snapped the old arm loose, put the new arm in and -- the dishwasher works like new! Thank you!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
carla from valdosta, GA
Parts Used:
WD22X10047
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Food particles had started stopping up spray arm and get them out.
Pulled old spray arm off and snapped new one on. Less than 3 minutes and works great. Dishes are cleaner now.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Eric from Raleigh, NC
Parts Used:
WD35X21041
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
wheel fel off bottom tray
but axle on new wheen and put axle on tray
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Von from SanBernardino, CA
Parts Used:
WD35X21041, WD28X24469
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
all 8 wheels broken from lower rack & basket broken
went to sears and was told axles not available ! after they sold my wife all 8 wheels in two diffrent colors. started looking on line found your web site I entered my model number. In a matter of minutes I found the parts checked stock ordered them and recived conformation.
prices and shiping are fair. ordered recived and installed parts in 4 days WOW ! wished all purchases went this smooth.

Von Neal
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Charles from Hixson, TN
Parts Used:
WD35X21041, WD12X10262, WD35X21041
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Lower rack wheels were falling off
Removed and replaced all rack wheels with new wheels and wheel axles. All I needed was new axles, as they are new and better, and solved the problem of the wheel falling off. G.E. should offer customers with this problem, new wheel axles at no charge, as they are very easy to exchange. The original axle was a bad design.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the PDW8800LB
121 - 135 of 482