FGBD2435NF0A Frigidaire Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- MICHAEL from TULSA, OK
- Parts Used:
- 5304517203
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Lower arm came off and melted.
Simple repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Christine from Marne, MI
- Parts Used:
- 809006501
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
bottem door gasket was shot and leaked
Took off front door panel with two screws. Found the part in the door. took it out and slide the new part in. My husband screwed the screws while I held the door in place. If I had known it was so easy to do I would have done it as soon as I got the part but I waited for my husbands help.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Philip from Freehold, NJ
- Parts Used:
- 809006501
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Interior bottom door gasket seal broken
Lower the door and remove bottom dish tray. Feel with fingers the area where gasket will be pulled from (just below bottom door edge) Pull old gasket from door edge into direction of inside dishwasher. Insert new one in same orientation as old (small slit to right side). New gasket strip will seat into door bottom.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jason from Lafayette, LA
- Parts Used:
- 5304532229
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Wheels on lower rack melted
Very, very easy. Pop off the old wheels and snap the new ones into place on the rack.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from Huntington Station, NY
- Parts Used:
- 154756401
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
door falls open
Slid dishwater out from cabinet, replace cable, slid unit back in , secure ---done! door has tension now.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Larry from Avon, IN
- Parts Used:
- 809006501
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Wrench set
Gasket bottom of door
Removed front of door to see how gasket was installed. removed door for proper cleaning of gasket area, removed old gasket cleaned area and installed new gasket in holder notch, reinstalled door adjusting alinement, reinstalled door front.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bonnie from Erie, PA
- Parts Used:
- 5304532235, 5304517203
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Lower spray arm and arm support became loose fell on the hot coil and melted.
First let me say I love this company, I have used them before and I will use them again.
Parts arrived quickly, unwrapped them, put the video
supplied by this site on my phone and the entire project was done in less than ten minutes. My dishwasher works like new. Thank you !
Parts arrived quickly, unwrapped them, put the video
supplied by this site on my phone and the entire project was done in less than ten minutes. My dishwasher works like new. Thank you !
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sandra from WILDERSVILLE, TN
- Parts Used:
- 5304532235, 5304517203
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Spray arm came off and melted mon heating element
Takes longer to open the machine and remove the lower basket than to do repair.
Snap arm and support together, align and twist in machine to lock in place.
Save yourself some time and buy the support. High risk it can be broken while being removed from the arm. I am glad I purchased a new one and didn't take the risk.
Snap arm and support together, align and twist in machine to lock in place.
Save yourself some time and buy the support. High risk it can be broken while being removed from the arm. I am glad I purchased a new one and didn't take the risk.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Danise from Brentwood, TN
- Parts Used:
- 809006501
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Dishwasher leaked at the bottom of the door
First I removed two screws that held the door panel on. Then I pulled out the old gasket, inserted the new one, replaced the door and screws and it was done! We tested the dishwasher and no more leaks!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from SPRING HILL, FL
- Parts Used:
- 5304523457, 5304538466
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers
Original hose needed replacement due to leaking holes
The replacement hose was not as long and the original and therefore did not fit into the track made for the original one. Though it was long enough to work, an additional 4 inches would have been an exact fit.
As a result, the replacement had to be duct taped to the side of the dishwasher to hold it in place. Otherwise, the new hose was of better quality that the flimsy original. All in all, I could have picked up 3 feet of rubber hose from an auto parts or hardware store cheaper and done the job just as well, if not better.
As a result, the replacement had to be duct taped to the side of the dishwasher to hold it in place. Otherwise, the new hose was of better quality that the flimsy original. All in all, I could have picked up 3 feet of rubber hose from an auto parts or hardware store cheaper and done the job just as well, if not better.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- carol from CHAPEL HILL, NC
- Parts Used:
- 5304525218
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Dishwasher door switch would not engage properly
Removed 6 screws from door front panel. Removed two wiring connectors and screws fromdoor latch Replaced and all is great
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- DANIEL from BRADENTON, FL
- Parts Used:
- 5304525218
- Difficulty Level:
- Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Son ripped open dishwasher while running and wouldn't close
Replace the latch. Got to cut off old latch, trim wires, install latch, and put on the dishwasher door cover back on with screws
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Larry from Signal Mountain, TN
- Parts Used:
- 154827601
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Leaking dishwasher door
For some strange reason my new dishwasher was installed without a door gasket, which caused a very small water leak. The gasket I purchased was installed in less than 5 minutes and corrected the problem immediately - a very easy task and I am no handyman!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from WOODWAY, TX
- Parts Used:
- 154701001
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Dishwasher leaking splash shield was cracked
Watched your video repair was easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from GLEN RIDGE, NJ
- Parts Used:
- A00126401
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Drain pump had failed.
Disconnected power, water, and drain tube from dishwasher. Pulled dishwasher out and laid it on right side. It was not necessary to remove the pump motor. When disconnecting the water line, it is better to remove 3/8 line from the appliance adapter rather that the appliance adapter from the dishwasher as the nylon connection tends to strip.
Was this instruction helpful to you?
Thank you for voting!