BGHD2433KF0 Frigidaire Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Rosemary from Desert Hot Springs, CA
- Parts Used:
- 154756401
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
The front door kept falling down
Broken friction cable on the right hand side. Remove screws that hold dishwasher to cabinet, pull out the dishwasher far enough to get to the friction cable and rear spring. Remove broken cable. Attach new cable to rear spring and connect to door hinge. Push back dishwasher and screw in the two screws that keep the dishwasher attached to the cabinet. Very simple.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Clinton, OH
- Parts Used:
- 809006501
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Leaking Door
Pulled out old gasket from bottom of door with needle nosed pliers and then put in new one in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Doris from Arkadelphia, AR
- Parts Used:
- 5304506516
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
loose spray arm
Unscrewed the old spray arm and replace with the new spray arm.
The best part was in the ordering process. Having the diagrams with the parts let me see that I was ordering the correct part. Thanks!
The best part was in the ordering process. Having the diagrams with the parts let me see that I was ordering the correct part. Thanks!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bob from YONKERS, NY
- Parts Used:
- 5304506516, 154406401
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken upper sprayer
Unscrewed upper sprayer by hand, screwed new one in by hand. Piece of cake!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- mike from Bartlett, IL
- Parts Used:
- 5304506516
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Spray arm came off in wash cycle
The spray arm comes off into 3 parts but is really only supposed to be one. I removed the nut from the old assembly and attempted to place the new assembly on by hand. The new nut seemed to be slightly smaller than the original so it would not attach to the dishwasher. Using a kitchen knife, I removed the new nut from the arm unit and attached the new arm to the original nut and it went back on easily. The connection of the new arm to the new nut was 3 tabs that needed to be depressed with the knife and was a different conection method than the assembly that kept coming off in the wash cycle. The replacement part had a much better design than the original.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lauren from Peabody, MA
- Parts Used:
- 5304535382
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
large holes in the bottom of the basket where pieces of plastic kept breaking off
I replaced the basket. No tools necessary. New basket seems sturdier than original. Very satisfied with my purchase.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jeffery from Excelsior Springs, MO
- Parts Used:
- 154637401
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers, Wrench (Adjustable)
No water was coming into dishwasher.
Unscrewed dishwasher from cabinet and pulled out about 1 foot. Took bottom plate off of dishwasher. Undid clamp on hose of discharge of inlet water valve and removed hose. Shut off water to water inlet valve and removed. Took wiring clip off of water inlet valve. Removed 2 screws holding water inlet valve in place. Installed new water inlet valve in reverse order.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ronald from Montgomery, TX
- Parts Used:
- 5304506516
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Upper wash arm bushing had worn
Discovered upper wash arm had come off. It looked like it was repairable, but the bushing/clip holding the arm came off after one wash. Looked on line and reviewed part and saw it was a one piece assembly from photos. Removed old assembly by unscrewing from top of washer and screwed new assembly in place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Grant from Fairview, TN
- Parts Used:
- 809006501
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
water leak right bottom corner
Fully open dishwasher door to horizontal position, remove lower dishwasher rack and relocate to another temp location, grab old lower door seal from right or left corner and pull completely out of door, lay the old bottom seal aside facing the same direction as once installed (seal has a notched side which faces the right side of door), match direction of the new seal with the old seal (match the notched side of seal to the right side of door), gently push the seal into the door starting on the right side (notched side of seal fits tightly into a receiving area inside the door), and finally push the remaining portion of the seal into door (aligning with the right side already properly seated inside dishwasher door). Close dishwasher and run water cycle to confirm leak.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Keith from Coventry, RI
- Parts Used:
- A01986801
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Center spray arm broke
I was able to pull out the top basket were the glasses are put then I lined up the back and the center plastic clip an slid on the center spray arm. It took about 2 miniutes
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from SIERRA VISTA, AZ
- Parts Used:
- 154579101
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Left side door spring replacment
First thing I did was turn off the power to the dishwasher, then remove the racks. Remove the foot plates, remove the two top screws holding the dishwasher. Then using the socket set, retract the two foot stands to pull the dishwasher forward. You may not have to do this step as I had to get it over tile. The pully springs are on the sides, easily replaced. After replacing the springs and I recommend replacing both at the same time, put everything back. The hardest part will be the foot plates, there are two and getting them lined up and the screws back in is a bit of a challenge. Then you are done.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sandra R. from Groveland, FL
- Parts Used:
- 5304523457
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Old hose was split
The Parts finder was the big help. After that all that was needed was to loosen the clamps and replace the old hose with the new one A piece of cake. Slide the washer back into place and replace the screws that hold it to the counter. Out and back in, 30min. top end to complet the job
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alan from Holley, NY
- Parts Used:
- 5304535382
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
silverware basket skunked
tossed the old one a replaced with a new.Hardest 10 second repair ever....It took 10 seconds had to open and close the door.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Craig from Marlborough, MA
- Parts Used:
- 5304535382
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
busted center portion of silverware basket
New one snaps into place easily.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Katy, TX
- Parts Used:
- 5304534829
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Fence in dishwasher rack rusted
Unsnapped three clips in lower rack securing old fence in rack. Attached clips to new fence and snapped assembly back into rack.
Was this instruction helpful to you?
Thank you for voting!