DW7600AWL1 Frigidaire Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- DAWINDER from HOUSTON, TX
- Parts Used:
- 5300809611
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Water leak
Replaced the gasket
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Barb from Bryan, OH
- Parts Used:
- 5300809611
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
The seal in the door was broken.
I had to replace the door gasket but it would not go in very easy..So I put the gasket in a sink of warm water so it would be more pliable. Then it went on fairly easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andy from Aptos, CA
- Parts Used:
- 5300809640
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
There were no wheels on the bottom rack of our dishwasher.
This could not have gone easier! As long as you get the proper parts it's a piece of cake. I wish everything was this easy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from Metairie, LA
- Parts Used:
- 154106202
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Wrench set
dishwasher was leaking at heating element connections
Both heating element brass nuts had a split in them. They had fallen off the heating element and were hanging on the electrical wires. I removed the wires from the heating element and removed the brass nuts from the wires. I then screwed the new nuts on the heating element and reattached the wires. problem solved. I want to thank you for having the parts I needed as Sears had discontinued them for this Kenmore appliance.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sherry from Smiths Grove, KY
- Parts Used:
- 154539802
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
rubber part on end of arm came off and melted
took out the top rack. removed the spray arm put the new one in place. put the rack back in place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Hyde Park, MA
- Parts Used:
- 5304507405
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Tub Wheels were worn & broken
Got the parts in a DAY! Wheels were broken and worn causing top tray to slip off runners- new wheels were easy to put in-used the screwsfrom the old ones and banged out the job in about 20 minutes, including letting my son help. Thanks Partselect, you've hooked a new DIY'er (my son)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jeff from Boonton Township, NJ
- Parts Used:
- 5300809611
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Worn out door gasket on dishwasher.
Removed old gasket and clean surfaces on tub and door before installing new gasket. New gasket has a small notch in the middle for top center. Install top then down sides for best results. Door gasket snaps into existing groove so no tools are required.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Lake Havasu City, AZ
- Parts Used:
- 5300809611
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Leak at lower door
Took out the old and installed the new and ran the dishwasher, no leak. Problem solved
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kevin from Old Orchard Beach, ME
- Parts Used:
- 154106202
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Wrench set
My dishwasher was leaking from and electrical connection at the heating element
There was an excellent "how to" video on the internet which also pointed me to the part I needed. I did not even remove the dishwasher as recommended. I removed the lower kick plate, removed the power connector at the leaking input, removed the bad nut and installed the new nut.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Oak Harbor, WA
- Parts Used:
- 154106202
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Wrench set
Brass Nut Cracked - Water Leaks O Floor
I removed the 2 screws that hold the dishwasher in place. Slide out the unit just far enough to access the brass nuts on the heating element. Pulled off the wire, and replaced the broken nut with the new nut. Replaced the wire, slide the unit back into place and reattached the 2 under counter screws. Done!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Niagara, WI
- Parts Used:
- 154085301
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
dish washer not washing
removed wire rack -removed nut from bottom sprayer-turned impeller housing CCW- removed screw from impeller -replaced impeller and tighten screw replaced other part and stared dish washer repairs were complete and now i have clean dishes
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Matt from Salisbury, NC
- Parts Used:
- 154106202
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
(leaking) heater element nuts cracked under dishwasher
power off, take off kickplate, unplug 2 wires and unscrew broken nuts, put new nuts on, plug wires back in,(run dishwasher one cycle to make sure no leaks) put kickplate back on, power on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William E from High Point, NC
- Parts Used:
- 154106202
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers, Wrench (Adjustable)
Broken heating element brass nut
Ditto the other comments. Easy, great savings. Perfect. Thank you!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Juergen from Shelbyville, IN
- Parts Used:
- 5300809611
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Dishwasher leaking at the door
Pulled the old gasket ou, cleaned the groove with a cloth. Then pushed the new one in, starting at the bottom. The curvatures are clearly marked, no guesswork.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steve A. from Lake Mary, FL
- Parts Used:
- 5300809018
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
Plastic bolt strips
This dishwasher has a plastic bolt that holds the actuator on. The action loosens the bolt and it wobbles and eventually comes off. After enough attempts the bolt will strip and need to be replaced. I took some 3M loctite this time to hold it in place. It is 24 years old, but still kicking
Was this instruction helpful to you?
Thank you for voting!