FFID2426TD4A Frigidaire Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Warren from GENTRY, AR
- Parts Used:
- 5304519906
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Popping clicking noise, could not hear water washing. Soap dispenser opened but soap just ran down to the bottom.
Hardest part was just disconnecting drain hose and water supply and pulling unit out.
Laid on its back disconnected power wires, then took my screw gun took out the two torx screws slide spring metal plate holder out and removed pump.
Sprayed water on new pump seals and put it back together. Super easy installation of new pump and dishwasher working properly again.
Laid on its back disconnected power wires, then took my screw gun took out the two torx screws slide spring metal plate holder out and removed pump.
Sprayed water on new pump seals and put it back together. Super easy installation of new pump and dishwasher working properly again.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Raymond from VERO BEACH, FL
- Parts Used:
- 5304533200
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Rack was rusting on the bottom due to the plastic no longer covering the metal
simply removed the old slide out rack and replace with new one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ron from Sublimity, OR
- Parts Used:
- 154756401
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Cable was broke
Opened door. Located 2 Phillips head screw s attaching the dishwasher to counter and removed them. Slid the dishwasher out about 8 inches. Love broken cable and removed . Inspect spring and attached new cable. Inspected opposite cable and spring. Tucked insulation around dishwasher and slid back into place. Reattached 2 Phillip screws and closed door.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Patricia from FAIRPORT, NY
- Parts Used:
- 5304507158
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The spray arm on the lower level had broken
Easy repair .part was perfect. Did have to you tube video to make sure I was doing it correctly. Instructions with part would be helpful.Part arrived quickly without issue!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert W from OSSINEKE, MI
- Parts Used:
- 5304533200
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Rack assembly was rusted or rotted out
Took the old rack out and placed the new one in. Easy peasy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from STEWARTSVILLE, NJ
- Parts Used:
- 5304532229
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Missing part
Just pushed it onto the rod that held the old one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bob from Clinton, OH
- Parts Used:
- 8581548276014
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Leaking tub seal
Just pulled the old gasket out and popped in the new. I did trim it too shrt however so be careful not to do that.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Hank from Fort Pierce, FL
- Parts Used:
- 5304532199, 807145201
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Making noise during operation.
Checked your videos and found the lower spray arm damaged (nubs worn down). Previous owner had some work done and didn't reinstall the parts properly. While during the repair, I also decided to replace the Detergent Dispenser and make a new spray shield. I guess the previous owner decided one wasn't needed.
Easy install, no noise.
Capt. Hank
Easy install, no noise.
Capt. Hank
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from DENVER, NC
- Parts Used:
- 5304507158
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Lower arm broken,
Replaced lower arm
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Leonard from N ROYALTON, OH
- Parts Used:
- 154825001
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Wrench set
The heating element (ring) showed signs of wear
I followed the steps on YouTube.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jonathan from Cherry Hill, NJ
- Parts Used:
- A00126401
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Dishwasher not draining
NOTE: I am a complete amateur, and had NEVER attempted to work on my own appliances before this. Diagnosis via web search determined that the drain pump was the most likely problem. PartSelect.com had the best prices and, as it turned out, the fastest delivery. I shut off the power to the dishwasher at the circuit breaker and turned off the water supply under the kitchen sink. I took all of the removable parts out of the dishwasher (lower rack, spray arm, strainer), and using a shop-vac, I emptied the water that had pooled at the bottom of the dishwasher. I removed the kickplate (2 screws) to disconnect the water line (pliers) and the drain hose clamp (flat screwdriver). Both of these had some water in them, so I used one of a few shop towels that I had handy to keep things dry. Opening the dishwasher gave me access to the screws that anchor the unit to the countertop, which I removed (phillips screwdriver). Loosening the adjustable feet and gently rocking the dishwasher dislodged it to the point where I could remove it, but not before laying cardboard down to protect the kitchen floor. Once removed, I flipped the unit over and disconnected the old drain pump's electrical leads, noting which one went where. Three star-shaped screws held the drain pump in place - one of which was difficult to get to, due to the size of my driver and the location of the main motor. I removed/replaced the pump, connected the electrical leads, flipped the dishwasher upright, and slid it back under the countertop. I re-extended the adjustable feet and made sure everything was level front-to-back and side-to-side before securing the two screws through the tabs into the countertop. Under the unit, I reconnected the water line, turned the supply back on, and checked for leaks. I reconnected the drain hose and then turned the power back on at the circuit breaker. I did a quick test run of the unit and not only did it drain properly, but there were no visible leaks. I will reinstall the kickplate in a week or so, after I can run a couple loads of dishes and ensure that there are no issues under the unit. With a small amount of web searching, some great help from the PartSelect crew, and a bit of fortitude, I saved hundreds of dollars and have a far better understanding of how my dishwasher works. That's a win-win in my book!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jimmy from COMSTOCK PARK, MI
- Parts Used:
- 154825001
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Wrench set
My heating element was cracked
Remover the cracked heating element with the new heating element.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rita from MEDANALES, NM
- Parts Used:
- 5304523457
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Dishwasher Sprang a Huge Leak
I pulled out the dishwasher and found the inlet tubing had a tear in the accordion part of the tube. I searched online for the model number and was directed to PartSelect. I ordered the inlet tubing, and it only took a few days to get to me. I then watched the video and was able to install the new tubing.
PartSelect is a life saver and I saved lots of money by not having to call a repairman.
PartSelect is a life saver and I saved lots of money by not having to call a repairman.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Karla from Hickory, NC
- Parts Used:
- 8581548276014
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
dishwasher leaked around the door
First I pulled out the old gasket, used this to measure for the new gasket, cut to right length, pushed new gasket into the track and washed a load of dishes. No leaks! This took about 2 minutes to complete.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Niklas from San Diego, CA
- Parts Used:
- 807145201
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
plastic tabs broke
Replaced the part and everything worked fine
Was this instruction helpful to you?
Thank you for voting!