FFID2426TS3A Frigidaire Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Janice from ELK GROVE, CA
- Parts Used:
- 5304506521
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Plug for soap dispenser.
My future son in law did it. Looked at instructions on the app for the part. Didn't take very long.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- GENE from BRONX, NY
- Parts Used:
- 5304506521
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Dispenser failed to operate
Uncomplicated repair. Remove door, remove old dispenser, install new dispenser.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Al from WOODBURY, MN
- Parts Used:
- 154827601
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Old gasket melted.
Watched installation video and followed directions. All went smoothly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andy from Grass Range, MT
- Parts Used:
- 5304507158
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The top part of the lower spray arm got stuck on something a broke off the lower part of spray arm.
The are 2 tabs on the bottom of the lower spray arm that I pushed in and the arm popped right off. All you have to do is push the new spray arm on until you hear it snap into place, and you are done. It is really easy to do, and the part fit perfectly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Catherine from CYPRESS, TX
- Parts Used:
- 5304533200
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
bottom dishwasher rack had melted prongs
I put in the new rack but discovered it only has prongs for a few dishes the rest of it is flat with NO prongs. So it doesn't really work.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ron from Sublimity, OR
- Parts Used:
- 154756401
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Cable was broke
Opened door. Located 2 Phillips head screw s attaching the dishwasher to counter and removed them. Slid the dishwasher out about 8 inches. Love broken cable and removed . Inspect spring and attached new cable. Inspected opposite cable and spring. Tucked insulation around dishwasher and slid back into place. Reattached 2 Phillip screws and closed door.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rita from MEDANALES, NM
- Parts Used:
- 5304523457
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Dishwasher Sprang a Huge Leak
I pulled out the dishwasher and found the inlet tubing had a tear in the accordion part of the tube. I searched online for the model number and was directed to PartSelect. I ordered the inlet tubing, and it only took a few days to get to me. I then watched the video and was able to install the new tubing.
PartSelect is a life saver and I saved lots of money by not having to call a repairman.
PartSelect is a life saver and I saved lots of money by not having to call a repairman.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Leonard from N ROYALTON, OH
- Parts Used:
- 154825001
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Wrench set
The heating element (ring) showed signs of wear
I followed the steps on YouTube.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jimmy from COMSTOCK PARK, MI
- Parts Used:
- 154825001
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Wrench set
My heating element was cracked
Remover the cracked heating element with the new heating element.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert & Kathleen from FAIRFAX, VT
- Parts Used:
- 154579101
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Door springs were stretched; with one broken
Followed the on-line tutorial. BINGO!!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert W from OSSINEKE, MI
- Parts Used:
- 5304533200
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Rack assembly was rusted or rotted out
Took the old rack out and placed the new one in. Easy peasy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Hank from Fort Pierce, FL
- Parts Used:
- 5304506521, 807145201
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Making noise during operation.
Checked your videos and found the lower spray arm damaged (nubs worn down). Previous owner had some work done and didn't reinstall the parts properly. While during the repair, I also decided to replace the Detergent Dispenser and make a new spray shield. I guess the previous owner decided one wasn't needed.
Easy install, no noise.
Capt. Hank
Easy install, no noise.
Capt. Hank
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sally from SPRINGFIELD, VT
- Parts Used:
- 140229954072
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
PRONGS WERE RUSTY AND PULLING THE RACK TO LOAD, RACK FELL DOWN.
Ordered a new upper rack, My husband installed in less than 10 mins. Good to go. So easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul J from LEXINGTON, MA
- Parts Used:
- 154579101
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
One door spring was broken - the other was spring.
Instead of moving the unit out from under the counter, I did the job with the unit in place: (1) long reach to remove the old springs and attach the new ones to the frame at back of the unit, (2) use a loop of string to hook onto the other end of the spring, stretch it a little, and keep it stretched by hooking the other end of the loop to the screw that adjusts the unit's height, (3) slip the end of the cable to the front end of the spring and check to make sure that the cable is on its pulley, (4) take the string off the adjusting screw and wiggle it to free it from the end of the spring. (For comfort, lie down on a yoga mat when you do this job - thanks to my wife for this helpful suggestion!)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sharon from HAMPTON, NH
- Parts Used:
- 5304506916
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Two of the tub wheels cracked and broke off.
Unscrewed the old ones, new ones come with screw built in and recrewed the new ones in. So easy.
Was this instruction helpful to you?
Thank you for voting!