CDBEH960TS0A Frigidaire Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- ELIZABETH from ROANOKE, VA
- Parts Used:
- 807145201
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
original part was damaged and dishes weren't clean
Removed 3 screws, swapped parts - done. Wonderful feeling and saved a service call. Works great.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Pam from Cherokee, AL
- Parts Used:
- 5304532229
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
missing a wheel on dish rack
just slid the wheel on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- MICHAEL from FT LAUDERDALE, FL
- Parts Used:
- 5304500204
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Water leak
watched a video, really easy fix. Solved the problem!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sharon from Alamogordo, NM
- Parts Used:
- 140229954072
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Top rack had rusted
Slid the rack out, removed the end pieces holding top rack in the sliding arms. Removed the spray arm. It was stiff & a bit hard to get off, but with a little careful prying it came off. Put that spray arm assembly back onto the new rack, slid the new rack back in place, put the end pieces back on and in less than 15 minutes, we were done. Part came in very quickly, I might add. I feel like I have a brand new dishwasher.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jonathan from New Hope, PA
- Parts Used:
- 154106202
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Wrench (Adjustable)
Brass nuts holding heating element in place had split
All you have to do power down the unit, then disconnect the power connections at the element and remove the old nuts and replace them with the new ones and tighten. Don't tighten too much, the element has a rubber seal that just needs the nut to snug it up.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andy from Grass Range, MT
- Parts Used:
- 5304507158
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The top part of the lower spray arm got stuck on something a broke off the lower part of spray arm.
The are 2 tabs on the bottom of the lower spray arm that I pushed in and the arm popped right off. All you have to do is push the new spray arm on until you hear it snap into place, and you are done. It is really easy to do, and the part fit perfectly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Catherine from CYPRESS, TX
- Parts Used:
- 5304533200
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
bottom dishwasher rack had melted prongs
I put in the new rack but discovered it only has prongs for a few dishes the rest of it is flat with NO prongs. So it doesn't really work.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from STEWARTSVILLE, NJ
- Parts Used:
- 5304532229
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Missing part
Just pushed it onto the rod that held the old one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Janice from ELK GROVE, CA
- Parts Used:
- 5304506521
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Plug for soap dispenser.
My future son in law did it. Looked at instructions on the app for the part. Didn't take very long.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- GENE from BRONX, NY
- Parts Used:
- 5304506521
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Dispenser failed to operate
Uncomplicated repair. Remove door, remove old dispenser, install new dispenser.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Al from WOODBURY, MN
- Parts Used:
- 154827601
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Old gasket melted.
Watched installation video and followed directions. All went smoothly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bob from Clinton, OH
- Parts Used:
- 154827601
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Leaking tub seal
Just pulled the old gasket out and popped in the new. I did trim it too shrt however so be careful not to do that.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Danny from Collierville, TN
- Parts Used:
- 5304500204
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Bottom seal on door came out and melted on heating element.
Took me about 2 minutes to repair, no tools to repair, very easy installation repair!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Raymond from VERO BEACH, FL
- Parts Used:
- 5304533200
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Rack was rusting on the bottom due to the plastic no longer covering the metal
simply removed the old slide out rack and replace with new one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Patricia from FAIRPORT, NY
- Parts Used:
- 5304507158
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The spray arm on the lower level had broken
Easy repair .part was perfect. Did have to you tube video to make sure I was doing it correctly. Instructions with part would be helpful.Part arrived quickly without issue!
Was this instruction helpful to you?
Thank you for voting!