Models > UC01041A > Instructions

UC01041A Frigidaire Dishwasher - Instructions

Jump to:

All Instructions for the UC01041A
31 - 45 of 77
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Michael from STEWARTSVILLE, NJ
Parts Used:
5304532229
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Missing part
Just pushed it onto the rod that held the old one
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lin from San Francisco, CA
Parts Used:
5300809611
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Dishwasher leak
At first remove the lower rack to give more room for you to lean over the inside of the dishwasher then remove the old gasket tub 90 inches long make sure that you know which side goes where, so that it will be easy to put the new one. Then press the gasket firmly on the side.Now you can start your dishwasher with no leak and saves you a lot of money for buying a new one.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lloyd from Wyomissing, PA
Parts Used:
5300809703
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Dishwasher door more difficult to open and close
Removed two screws holding the dishwasher in place under the cabinet. Pulled the dishwasher out to expose the door springs. Removed the old springs and installed the new ones in just a few minutes. Pushed the dishwasher back into the cabinet and replaced the screws. Job done.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Daniel from Los Angeles, CA
Parts Used:
5304532229
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Lower rack got hung up & wouldn't roll
I snapped on the new roller and bingo! problem solved.
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Vincent from East Stroudsburg, PA
Parts Used:
5304532229
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
broken rack rollers
Two rollers on the lower rack were missing and one was flattened. I popped off the bad roller and snapped the three new rollers in place, all by hand. Took about 60 seconds.
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
denise from New Lisbon, NJ
Parts Used:
5300809611
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Water was leaking out of the door
I pulled the old door gasket out, cleaned the guck out and pushed the new one in it's place.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Donald from Elkton, MD
Parts Used:
5304532229
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Two wheels broke off
Snapped new wheels into place on the axel. New wheels were exactly like the old ones
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jonathan from Falls Church, VA
Parts Used:
5304532229
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Half the wheels were missing from the lower rack.
So easy it shouldn't even count as a repair, really. The dishwasher, there when I bought the place, had a lower rack that wouldn't roll out as it should. That's because there were no wheels on the left side.

The rack lifts out easily. These wheels snap on to small protrusions from the wire rack.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Daniel from Riley, MI
Parts Used:
5300809703
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
old springs were broken
used the pliers to grip the end of the spring, extended it and removed it from the door and frame. The install then followed. It takes longer to remove the front panel than to do the repair.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
James from Longview, WA
Parts Used:
5304532229
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Broken clip would no longer secure wheel
Snapped the new one in. One second repair - like new.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Juergen from Shelbyville, IN
Parts Used:
5300809703
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Socket set
Door spring was broken
I removed the front panel below the door. There are 4 Hex screws, two at the top (accessible with the door open) and two at the bottom. After removing the screws, the panel came off, and I could reach inside to replace the springs. I found it easier to use a socket wrench than a screw driver.
Easily done. Anybody can do it. It took longer to clean up the panel than to do the actual repair.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
DAWINDER from HOUSTON, TX
Parts Used:
5300809611
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Water leak
Replaced the gasket
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Christopher from Pensacola, FL
Parts Used:
5300809703
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Door Spring broken, door hard to close.
I removed two screws that hold unit to countertop,
just pulled out unit about two inches. Removed broken door springs. Installed new door springs and pushed unit back into place and installed the 2 countertop screws DONE.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
michael from McDonough, GA
Parts Used:
5300809703
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
broken door springs
very simple to do....attach spring to door...stretch to hole in frame and attach there...easy as 123
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Russell from Gurnee, IL
Parts Used:
5300809703
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Wrench set
Broken door spring
In about 20 minutes, I was able to remove the front panel and access the springs. Besides a hard water line in the way, it was a snap.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the UC01041A
31 - 45 of 77