EIDW6105GB1 Electrolux Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Craig from Yuma, AL
- Parts Used:
- 154614002
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
No water flow
Changed out Motor and Pump also canged out control box but no joy
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Toledo, OR
- Parts Used:
- A01986801
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The spray arm center moving part was broken off the stationary part.
I used a screwdriver to pry the Spray Arm Center snaps loose from the top drainer basket, and the same screwdriver to pry the Spray Arm Center into position. Job done..!!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary from Brighton, IL
- Parts Used:
- A01986801
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
was not washing dishes good. rubber gasket was all soft like putty didn't seal
took old arm off and put new one on. very simple
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sherry from Smiths Grove, KY
- Parts Used:
- 154539802
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
rubber part on end of arm came off and melted
took out the top rack. removed the spray arm put the new one in place. put the rack back in place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tracie from Tyler, TX
- Parts Used:
- 154610501
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken bracket
Easily removed the broken bracket and snapped the new one in its place. Took less than 30 seconds!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jessie from Covington, WA
- Parts Used:
- A01986801
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
dishes where not getting clean
I ordered the part and snapped it into place without any problems. I didn't even have to take the rack out to do it.It took about 4 mins.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Johnie from Aztec, NM
- Parts Used:
- 5304507354
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Dispenser would not dispense.
Removed 4 screws on door cover, 6 screws on dispenser 4 wires and reinstalled new one. Done less than 20 minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Melissa from Black Hawk, CO
- Parts Used:
- 154508201
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The center spray arm with manifold was warped and did not spin when the dishwasher was running.
We snapped the broken spray arm off, and snapped the new arm on. We had to use the screw driver as leverage to snap on new spray arm.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Hope from Garland, TX
- Parts Used:
- A01986801
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Arm Broke
First I tried to pry the arm off the basket with a screwdriver. Then I googled it and there were the simple instructions, and I followed them, pull to take off, to put on push after aligning arm on basket til it snaps on.
Was this instruction helpful to you?
Thank you for voting!