Models
>
EWDW6505GB0
EWDW6505GB0 Electrolux Dishwasher
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for EWDW6505GB0
Viewing 7 of 7
Manuals & Guides for EWDW6505GB0
Click to downloadInstall
Installation Instructions
(1.65MB)
Install
Installation Instructions
(1.17MB)
Manual
Owner's Manuals
(3.88MB)
Manual
Owner's Manuals
(22.01MB)
Wiring
Wiring Diagram
(1.6MB)
Keep searches simple, eg. "belt" or "pump".
$135.19
Upper Rack Assembly - T3 PRO. This is the complete upper rack and the wash arm.
In Stock
In Stock
$59.61
This part releases the detergent and rinse aid into the dishwasher. NOTE: Color may vary but the part will function the same as the original.
In Stock
In Stock
In Stock
In Stock
In Stock
Special Order
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for EWDW6505GB0
Viewing 9 of 9Not cleaning dishes properly
Fixed by these parts
How to fix it
Leaking
Fixed by these parts
How to fix it
Will not dispense detergent
Fixed by these parts
How to fix it
Door latch failure
Fixed by these parts
How to fix it
Not draining
Fixed by these parts
How to fix it
Will Not Start
Fixed by these parts
How to fix it
Will not fill with water
Fixed by these parts
How to fix it
Door won’t close
Fixed by these parts
How to fix it
Not drying dishes properly
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- C from Covina, CA
- Parts Used:
- 5304507354
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Dispenser door broken.
Disconnect from power
Unscrewed 4 phillips screws from top of outer door.
Unscrewed 2 screws each siide of door.
Lower outer door section drops away.
Note wiring sequence on dispenser, then disconnect wires.
Unscrew 6 screws on dispenser and lift dispenser out.
Place new dispenser in place (note orient ... Read more ation), ann fasten in place with screws, remembering to replace wire retainer on left lower screw.
Reconnect wires to dispenser correctly.
Slide lower outer door over tabs and secure with the 4 side screws.
Ensure lower door is up under control panel and secure with the 4 top screws.
Fill dispenser with detergent, reconnect power and test run while enjoying a cup of tea in celebration of a job well done..
Unscrewed 4 phillips screws from top of outer door.
Unscrewed 2 screws each siide of door.
Lower outer door section drops away.
Note wiring sequence on dispenser, then disconnect wires.
Unscrew 6 screws on dispenser and lift dispenser out.
Place new dispenser in place (note orient ... Read more ation), ann fasten in place with screws, remembering to replace wire retainer on left lower screw.
Reconnect wires to dispenser correctly.
Slide lower outer door over tabs and secure with the 4 side screws.
Ensure lower door is up under control panel and secure with the 4 top screws.
Fill dispenser with detergent, reconnect power and test run while enjoying a cup of tea in celebration of a job well done..
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Keith from Coventry, RI
- Parts Used:
- A01986801
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Center spray arm broke
I was able to pull out the top basket were the glasses are put then I lined up the back and the center plastic clip an slid on the center spray arm. It took about 2 miniutes
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Justin from Miami, FL
- Parts Used:
- 5304507354
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Broken door on dispenser
The only difficultpart was to figure out how to remove the stainless cover from the door. Seems it slides upwards after screws are removed. After that it is self explainatory and goes back together in 5 minutes.
Was this instruction helpful to you?
Thank you for voting!