FDPC4314AB Electrolux Dishwasher - Instructions

Watched installation video and followed directions. All went smoothly.

I pulled out the dishwasher and found the inlet tubing had a tear in the accordion part of the tube. I searched online for the model number and was directed to PartSelect. I ordered the inlet tubing, and it only took a few days to get to me. I then watched the video and was able to install the new tubing.

PartSelect is a life saver and I saved lots of money by not having to call a repairman.

First remove the kick plate.
Then look with a flashlight & mirror to make sure which, the spring and or the Spring Linkage are broken.
With the door open, to have less tension on the spring, replace the spring and or the spring linkage.
Attach the kick plate

Remover the cracked heating element with the new heating element.

I followed the steps on YouTube.

We pulled the dishwasher out enough th expose the sides where the springs are attached. We removed the oldsprings and attached the new ones. Then put the dishwasher back in place.

Removed the screws holding the dishwasher in the counterspace. Pulled it out far enough to re-attach the new spring, scoot it back in place, and put the screws back to hold it in, and attach the plate to the bottom that was taken out first. Good to go.

I snapped on the new roller and bingo! problem solved.

Two rollers on the lower rack were missing and one was flattened. I popped off the bad roller and snapped the three new rollers in place, all by hand. Took about 60 seconds.

Replaced the part and everything worked fine

First I pulled out the old gasket, used this to measure for the new gasket, cut to right length, pushed new gasket into the track and washed a load of dishes. No leaks! This took about 2 minutes to complete.

Never worked on a dishwasher before but quickly learned that on this particular one, it's only this thin little brass nut that tightens down the element from the underside of the washer. If not tight enough, water drips right down onto the electrical connections. In this case water began to drip and the heat from the electrical current began melting a clear rubber shield thing. Luckily I was home during the cycle and figured out the problem. Great website that seems to have all necessary parts for my washer. Quick shipment!

So easy it shouldn't even count as a repair, really. The dishwasher, there when I bought the place, had a lower rack that wouldn't roll out as it should. That's because there were no wheels on the left side.

The rack lifts out easily. These wheels snap on to small protrusions from the wire rack.

Snapped the new one in. One second repair - like new.

This is probably the easiest home repair I have ever done! I simply lifted out the screen exposing the Cover and Stem Assembly. It was held on by three screws. I removed the screws and lifted off the old part. (It had been there for over 10 years so I had to push a little to free it.) I then replaced it with the new part and replaced the three screws. It now works fine. One of those home repairs that is so simple but makes it look like you know what you are doing!