CDB900NB2A Crosley Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Doris from Arkadelphia, AR
- Parts Used:
- 5304506516
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
loose spray arm
Unscrewed the old spray arm and replace with the new spray arm.
The best part was in the ordering process. Having the diagrams with the parts let me see that I was ordering the correct part. Thanks!
The best part was in the ordering process. Having the diagrams with the parts let me see that I was ordering the correct part. Thanks!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bob from YONKERS, NY
- Parts Used:
- 5304506516, 154406401
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken upper sprayer
Unscrewed upper sprayer by hand, screwed new one in by hand. Piece of cake!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- mike from Bartlett, IL
- Parts Used:
- 5304506516
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Spray arm came off in wash cycle
The spray arm comes off into 3 parts but is really only supposed to be one. I removed the nut from the old assembly and attempted to place the new assembly on by hand. The new nut seemed to be slightly smaller than the original so it would not attach to the dishwasher. Using a kitchen knife, I removed the new nut from the arm unit and attached the new arm to the original nut and it went back on easily. The connection of the new arm to the new nut was 3 tabs that needed to be depressed with the knife and was a different conection method than the assembly that kept coming off in the wash cycle. The replacement part had a much better design than the original.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lauren from Peabody, MA
- Parts Used:
- 5304535382
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
large holes in the bottom of the basket where pieces of plastic kept breaking off
I replaced the basket. No tools necessary. New basket seems sturdier than original. Very satisfied with my purchase.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ronald from Montgomery, TX
- Parts Used:
- 5304506516
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Upper wash arm bushing had worn
Discovered upper wash arm had come off. It looked like it was repairable, but the bushing/clip holding the arm came off after one wash. Looked on line and reviewed part and saw it was a one piece assembly from photos. Removed old assembly by unscrewing from top of washer and screwed new assembly in place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lisa from Fort Lauderdale, FL
- Parts Used:
- 5304517203
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Lower spray arm came off and melted against the heating element
I installed the new spray arm without any tools and it worked perfectly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- shannon from baltimore, MD
- Parts Used:
- 5304517203
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
old spray arm had melted and wasnt spraying
I removed the old spray arm by pulling it off of the base then I pushed the new one on and made sure it was on properly then I pit the base back into the dishwasher and it was good as new!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Grant from Fairview, TN
- Parts Used:
- 809006501
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
water leak right bottom corner
Fully open dishwasher door to horizontal position, remove lower dishwasher rack and relocate to another temp location, grab old lower door seal from right or left corner and pull completely out of door, lay the old bottom seal aside facing the same direction as once installed (seal has a notched side which faces the right side of door), match direction of the new seal with the old seal (match the notched side of seal to the right side of door), gently push the seal into the door starting on the right side (notched side of seal fits tightly into a receiving area inside the door), and finally push the remaining portion of the seal into door (aligning with the right side already properly seated inside dishwasher door). Close dishwasher and run water cycle to confirm leak.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from SIERRA VISTA, AZ
- Parts Used:
- 154579101
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Left side door spring replacment
First thing I did was turn off the power to the dishwasher, then remove the racks. Remove the foot plates, remove the two top screws holding the dishwasher. Then using the socket set, retract the two foot stands to pull the dishwasher forward. You may not have to do this step as I had to get it over tile. The pully springs are on the sides, easily replaced. After replacing the springs and I recommend replacing both at the same time, put everything back. The hardest part will be the foot plates, there are two and getting them lined up and the screws back in is a bit of a challenge. Then you are done.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sandra R. from Groveland, FL
- Parts Used:
- 5304523457
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Old hose was split
The Parts finder was the big help. After that all that was needed was to loosen the clamps and replace the old hose with the new one A piece of cake. Slide the washer back into place and replace the screws that hold it to the counter. Out and back in, 30min. top end to complet the job
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alan from Holley, NY
- Parts Used:
- 5304535382
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
silverware basket skunked
tossed the old one a replaced with a new.Hardest 10 second repair ever....It took 10 seconds had to open and close the door.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Craig from Marlborough, MA
- Parts Used:
- 5304535382
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
busted center portion of silverware basket
New one snaps into place easily.
Was this instruction helpful to you?
Thank you for voting!
Water leak behind kick-plate
Water had been dripping for quite some time causing the floor boards to warp and buckle causing the door to no longer align. Water drip could be seen coming from the motor area. Ordered the O rings and replaced. Get Motor & Pump schematic Pub to visualize how parts fit together. I recommend getting motor (~$90)which comes with O rings (~$50 for O rings alone) because, as it turns out, the leak was in motor. I will post repair process in separate posting.
Was this instruction helpful to you?
Thank you for voting!
Leaky on bottom right
Pulled out old gasket and shield guards and put in new ones. No tools needed. Piece of cake??
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- JESSICA from CLARKSVILLE, TN
- Parts Used:
- 5304506516, 809006501
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
upper arm kept coming off and leaking at bottom of dishwasher
unscrewed the old upper arm spray nut off and rescrewed the new one on....very easy...then I took the old gasket out of the bottom of the door and replaced by sliding it in. very simple....less then 15 minutes for both and have solved my issues.
Was this instruction helpful to you?
Thank you for voting!