SGS5362BS (15) Bosch Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Lawrence from FREDERICKSBRG, PA
- Parts Used:
- 00499500
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Pliers
Overfill then no fill
Remove bottom kick plate and raise the feet up. Remove attachment from the top to counter. Slide out. Facing the unit, remove left hand side sheet metal cover. The unit is behind this cover. Unhook the hose on the lower end. Pop the new one in and hook it up!! Test on quick rinse and see results. If ok return to normal as disassembled. Make sure to level the unit after tucking it back in. Enjoy!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Travis from Hermon, NY
- Parts Used:
- 00642239
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)
Getting to the part at the bottom of the dishwasher was a little pain.
Everything went great installing the new drain pump. Our dishwasher works like it’s brand new again. I would recommend part select to anyone that needs to repair their dishwasher parts or any applications parts.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ranaye from BECKER, MN
- Parts Used:
- 00165256
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Not getting water
shut off water, pull dishwasher out, took side insulation off, unhooked what was connected to the float switch and replaced the new with the old. Reconnected everything and put insulation back and wa-la , all done
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mary from HUNTINGTN STA, NY
- Parts Used:
- 17008311
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Drain filter got old fell apart
Unscrewed the old piece screwed in the new
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andrew from Redding, CT
- Parts Used:
- 00490467
- Difficulty Level:
- Difficult
- Total Repair Time:
- 30 - 60 mins
Needed to replace dispenser
The video pretty much showed it all except...if you have a custom panel on the front like ours did. In that case, yiu have to remove the torx screws along the top PLUS to extras in the side of the part that protrudes into the tub of the washer. Those two are key to releasing the front panel and are also held in with fairly flimsy spring steel so be careful. Otherwise, pretty easy to do.
Was this instruction helpful to you?
Thank you for voting!