SHX5AVF5UC (22) Bosch Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Water leaking and high pitch noise mid way through operation.
Mistakenly opened covers for the drain pump. Had to put those covers back in place.
Heater and pump installed easily with a bit of careful maneuvering the plugs and plug housing from the exterior. Pump installed in place easily. Clamp fit perfectly.
Heater and pump installed easily with a bit of careful maneuvering the plugs and plug housing from the exterior. Pump installed in place easily. Clamp fit perfectly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mary from ELGIN, TX
- Parts Used:
- 00669221
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers
the door has to be taken apart.
My son and my husband did it. I watched.
They both injured their fingers.
But it stopped the leak!
They both injured their fingers.
But it stopped the leak!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Toni from GREENSBORO, NC
- Parts Used:
- 00611475
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
One Dishwasher bottom rack wheel broke
Popped the new one right on!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- tim from dumfries, VA
- Parts Used:
- 00628998
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Socket set
Lip on handle cap snagged on clothing, cracked the lip and the body of the part
Removed the 12 torx-headed sheet metal screws holding tub-side of the door together.
Opened the door assembly, the wiring harness for the control panel prevents the separation of the door interior and exterior, which is necessary to access the door handle mounting hardware.
Lifted the control panel assembly up, which allowed separation of the door components to access the door handle hardware.
Removed and replaced the broken mount.
When reassembling the door, be careful to align the control panel and snap it back into the groove on the external door assembly be fore reinstalling the screws. Line up the screws carefully to allow flush mounting and avoid stripping the interior screw holes.
Opened the door assembly, the wiring harness for the control panel prevents the separation of the door interior and exterior, which is necessary to access the door handle mounting hardware.
Lifted the control panel assembly up, which allowed separation of the door components to access the door handle hardware.
Removed and replaced the broken mount.
When reassembling the door, be careful to align the control panel and snap it back into the groove on the external door assembly be fore reinstalling the screws. Line up the screws carefully to allow flush mounting and avoid stripping the interior screw holes.
Was this instruction helpful to you?
Thank you for voting!