SHX43C05UC (40) Bosch Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Bill from Seattle, WA
- Parts Used:
- 00494772
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water leakage from the dishwasher; unknown source.
Followed the video on your site and it was an easy install with no more leakage.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Travis from Hermon, NY
- Parts Used:
- 00642239
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)
Getting to the part at the bottom of the dishwasher was a little pain.
Everything went great installing the new drain pump. Our dishwasher works like it’s brand new again. I would recommend part select to anyone that needs to repair their dishwasher parts or any applications parts.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Danette from SANTA FE, NM
- Parts Used:
- 00165314
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Missing/broken wheel on right side of lower dishwasher rack
I snapped the part in and voila!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary from NEW PARIS, IN
- Parts Used:
- 00166623
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Lid for the streak treatment wouldn't stay shut.
Use screwdriver to gently wedge the side of the dispenser body apart enough to pop out the old kid, then insert the new kid in it's place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ranaye from BECKER, MN
- Parts Used:
- 00165256
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Not getting water
shut off water, pull dishwasher out, took side insulation off, unhooked what was connected to the float switch and replaced the new with the old. Reconnected everything and put insulation back and wa-la , all done
Was this instruction helpful to you?
Thank you for voting!
Not pumping out
Remove spray arm. Pullout. Micro filter big screen . Tork bolt cover and small pliers to grab check valve flapper.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from PENN VALLEY, PA
- Parts Used:
- 00615079
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Clogged, old filter- dirty dishes
Removed old filter and replaced with new filter. Easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andrew from Redding, CT
- Parts Used:
- 00490467
- Difficulty Level:
- Difficult
- Total Repair Time:
- 30 - 60 mins
Needed to replace dispenser
The video pretty much showed it all except...if you have a custom panel on the front like ours did. In that case, yiu have to remove the torx screws along the top PLUS to extras in the side of the part that protrudes into the tub of the washer. Those two are key to releasing the front panel and are also held in with fairly flimsy spring steel so be careful. Otherwise, pretty easy to do.
Was this instruction helpful to you?
Thank you for voting!