SHP7PT55UC (07) Bosch Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Jim from EDINA, MN
- Parts Used:
- 00645038
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Over the years the filter became too clogged with embedded particles
Really simple. You pull out the drain filter plate and pull the filter off the support and replace. I gave everything a good cleaning and put it back in place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bill from Seattle, WA
- Parts Used:
- 00494772
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water leakage from the dishwasher; unknown source.
Followed the video on your site and it was an easy install with no more leakage.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Peter from LEXINGTON, KY
- Parts Used:
- 00645038
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Filter-Micro was clogged with lime from hard water.
Replacement was fast and very simple. Was completed in less than 5 minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Daniel from AUBURN, IN
- Parts Used:
- 00611323
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
dishwasher not draining, dishes dirty
replacing the sensor was simple, just unplug and turn it out, but didn't solve the problem, it's a float sensor that doesn't show up on the tech sheet in the dishwasher or anywhere in troubleshooting on the internet I could find.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sheldon from ROCKAWAY, NJ
- Parts Used:
- 00745856
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
We accidentally damaged the upper spray arm
Easily removed the old one by carefully pulling it and repeated this procedure to replace it. Total time took less than 15 minutes
Was this instruction helpful to you?
Thank you for voting!
Bosch mounting bracket install
Hello,
I received the parts 12/10/23. Thank you for your prompt shipping. It was exactly what I needed and the fix went quickly with no issues.
I ordered two of PS8728568 (Mounting Bracket), because on your site for that part it identifies that each bracket is sold individually. (Reference: “Part Description” section). In addition, on that same web page under the “Question and Answers” section it identifies that each bracket is sold individually.
However, what I received was, two packages with each package having two brackets in it. It’s understandable, since you need two brackets for each dishwasher.
Obviously, this is completely contrary to what your web page states. In reality, each package is sold with a pair of brackets.
I have not opened the second package and as such it is completely resaleable. As per your Return Policy , I’d like to request a refund for the second packet of brackets and have you cover the return shipping of that package. Please advise next steps.
I received the parts 12/10/23. Thank you for your prompt shipping. It was exactly what I needed and the fix went quickly with no issues.
I ordered two of PS8728568 (Mounting Bracket), because on your site for that part it identifies that each bracket is sold individually. (Reference: “Part Description” section). In addition, on that same web page under the “Question and Answers” section it identifies that each bracket is sold individually.
However, what I received was, two packages with each package having two brackets in it. It’s understandable, since you need two brackets for each dishwasher.
Obviously, this is completely contrary to what your web page states. In reality, each package is sold with a pair of brackets.
I have not opened the second package and as such it is completely resaleable. As per your Return Policy , I’d like to request a refund for the second packet of brackets and have you cover the return shipping of that package. Please advise next steps.
Was this instruction helpful to you?
Thank you for voting!
The washer had an error message in the display of E:09. I called Bosh on customer srevice and she said that the heat pump was not working and needed to be replaced. Since the motor is the main part for this that needed to be replaced as well. The pars were under $200.00 total so we oted to fix this
We followed the video and had no problems with leaks at all afterwards. The parts fit perfectly and the machine is working great again.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- spencer from gilbertsville, PA
- Parts Used:
- 12012913
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
Handle on Bosch dishwasher had cracked
1) Remove the three torx screws securing the handle.
2) Open door. Placing some cushions under the door makes the operation easier.
3) Remove the 12 torx screws securing the door skin. Note the screws are of two sizes. The lower 6 are shorter and fatter than the upper 6, that also secure the control panel.
4) It’s useful to have a 2nd person or a counterweight to secure the door once the skin is removed.
5) Remove the old handle by snapping the securing tabs.
6) New handle is press to fit.
7) Return skin to door and re-insert screws to secure.
8) Re-insert the three handle screws.
Notes
1) A three red wire cable plug was floating in the breeze when i removed the skin. I assumed it had pulled loose during removal of the skin so inserted back into the control panel but the washer would not power up with it inserted. On removal it worked fine. Not sure it it serves a model specific function.
2) It may be possible to use a car trim pry tool to remove the handle but I was concerned the stainless might be distorted.
2) Open door. Placing some cushions under the door makes the operation easier.
3) Remove the 12 torx screws securing the door skin. Note the screws are of two sizes. The lower 6 are shorter and fatter than the upper 6, that also secure the control panel.
4) It’s useful to have a 2nd person or a counterweight to secure the door once the skin is removed.
5) Remove the old handle by snapping the securing tabs.
6) New handle is press to fit.
7) Return skin to door and re-insert screws to secure.
8) Re-insert the three handle screws.
Notes
1) A three red wire cable plug was floating in the breeze when i removed the skin. I assumed it had pulled loose during removal of the skin so inserted back into the control panel but the washer would not power up with it inserted. On removal it worked fine. Not sure it it serves a model specific function.
2) It may be possible to use a car trim pry tool to remove the handle but I was concerned the stainless might be distorted.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rick from LANDENBERG, PA
- Parts Used:
- 11018097
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
My flow tube had a hole in it
Initially, I received an E15 error. I evaluated for leaks but couldn't find anything except for water in the bottom of the dishwasher after about 30 minutes of the initial cycle. After discovering the hole in the flow tub, I order the part. It came a few days later & replace the part within a 15 minutes of receiving it. I didn't think it would resolve the issue but it did. Thank you!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- daniel from AUBURN, IN
- Parts Used:
- 00611320
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
dishwasher not emptying tub, dirty dishes when the dishwasher said the cycle was done
easy repair, but the check valve wasn't the problem, it was the float switch that isn't on the tech sheet in the dishwasher or mentioned as a possible culprit anywhere I could find on the internet
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Toni from GREENSBORO, NC
- Parts Used:
- 00611475
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
One Dishwasher bottom rack wheel broke
Popped the new one right on!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from MOORPARK, CA
- Parts Used:
- 00745856
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Top arm water connection to rear wall - all seals eroded and leaking
Removed the middle basket and turned it upside down. Unplugged the spray arm from the middle basket. Snapped the new spray arm into the middle basket.
Installed middle basket into slides.
It works great. Great site for parts - reasonable prices too
Installed middle basket into slides.
It works great. Great site for parts - reasonable prices too
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- james from PARSIPPANY, NJ
- Parts Used:
- 00611475
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Four wheels on the lower dishwasher rack came off and got lost.
I bought replacement wheels.
I put them on the post, and they snapped onto the vertical post very easily. Job done.
I put them on the post, and they snapped onto the vertical post very easily. Job done.
Was this instruction helpful to you?
Thank you for voting!