SHX9PT75UC (73) Bosch Dishwasher - Instructions

First - I watched 2 or 3 videos on how it was done. The operation was not as easy as the videos made it out to be. Removal of the old unit was straight forward using 6 coins as shims to spread open the metal clips that hold the unit in place was essential. One issue not covered well in the videos is supporting the control panel after it was removed. the wires hang and are supporting the panel which is not good. I used a bunch of masking tape to secure the control panel to the top of the door. Also - installing the new unit can really only be done by first, fully engaging the top of the dispenser and then forcibly "pushing" (I used a rubber mallet) the bottom into place. you need to make sure the clips are locked in on all sides. After the dispenser is in place and the wiring harness has been reattached, you need to tape the wiring onto the door to keep them out of the way. I then very loosely reattached the control unit by the top 2 screws. I then lowered to the door flat and weighted it down. I used a clamp on each side of the door to lift the cover up into place unit until it could screwed. and then jimmied the control panel into place

Removed the 12 torx-headed sheet metal screws holding tub-side of the door together.

Opened the door assembly, the wiring harness for the control panel prevents the separation of the door interior and exterior, which is necessary to access the door handle mounting hardware.

Lifted the control panel assembly up, which allowed separation of the door components to access the door handle hardware.

Removed and replaced the broken mount.

When reassembling the door, be careful to align the control panel and snap it back into the groove on the external door assembly be fore reinstalling the screws. Line up the screws carefully to allow flush mounting and avoid stripping the interior screw holes.