ADB2500AWB Amana Dishwasher - Instructions

11 retaining screws were #1 Robertson screws which I did not have a screwdriver for, requiring a trip to the hardware store to purchase one (cost negligent, about $1.99). Several screws were so tight they required extreme force to remove, normally not a problem but making it very difficult for an elderly disabled person. The two electrical plugs were extremely tight, requiring a small flat screwdriver and much diligence to remove the old latch handle without breaking the wire plugs. Once the old latch was removed plugging the wires into the new one and installing in reverse order was a breeze. I would not recommend this operation for the faint of heart, regardless of the reviews I read proclaiming how fast and easy it is.

I just removed the handle assembly then looked for the part number and luckily it was available through this merchant. I did a thorough inspection and it's compatible. Just make sure to take pictures before you remove the broken part at least to guide you when installing the new part.

I initially took everything out and cleaned everything with the shop vac, and outside with the garden hose. That did not work, so I looked on parts select for a new accumulator filter, as I was not able to clean that very well. To install the new filter, I removed the sliding racks, top and bottom, and the water manifold, then removed the lower wash arm, then the parts under that, the filter plate, the outlet, the impeller, all the way to the accumulator filter. After removing that, installation was the reverse. I also cleaned the middle washing arm, and the lower, as I noticed food particles blocking the outer holes. All is good now, and the dishwasher, which we use almost every day, is working fine.

I unplugged the dishwasher under the sink. I opened the dishwasher up and took out the 12 screws holding the inside door facing on. I gently moved the door facing down towards the dishwasher to reveal the door locking mechanism at the top of the door. I unplugged the mechanism and plugged in the new one. I put the door back together the same way I had taken it apart. In all it took about 12 minutes. Works like a charm.

Routine repair. There are videos on the net that show exactly how to replace the filter unit. However, when you order the filter, order a replacement pump impeller. The impeller must be removed to remove the filter on this model. The impeller was stuck on the shaft, and I had to destroy it with the side cutter pliers to get it off. Before putting the new one on, clean the pump shaft thoroughly and lube the shaft with silicon lube or vaseline jelly. Clean the bottom of the water pan thoroughly, then reassemble. Then pour one cup of vinegar in the bottom of the dishwasher and run it with no dishes. This will clean the inside of the dishwasher.

My 14 year old grandson was able to repair this for me in less than 15 minutes! The repair was very simple. First, he removed the inside door panel, then took out the old handle and switch. (also remember to turn off the electricity to the dishwasher!) The new handle, and switch assembly fit right in, and he finished up; with screwing the door panel back in place.

Repair was very quick. Pop the lock on each rail endcap with a flathead screwdriver, remove endcap and set aside. One at a time, unclip each wheel from it's mount point and replace with new wheel, clipping it back into place. Once all four are done, reinsert the end caps and re-engage the locks (can be done by hand. Total repair time was maybe 5 minutes. Upper rack slides like new again.

My husband who is not handy, went to UTube typed in Handle Latch Assembly and got step by step instructions.