GLT3615LT0 Whirlpool Cooktop - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Stephen from Ladera Ranch, CA
- Parts Used:
- 3191293
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set, Wrench set
Worn out spring assembly in valve.
This was remove and replace of burner valve on a rangetop stove. Removed front pannel of stove. Removed lower panel support. Removed ignition/spark material/peice (slides right off). Unscrewed valve form underneath through access hole, and unscrewed gas connection on top. Removed and eplaced with new valve and reassembled everything in order. Fairly straight forward.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Leanne from Huntingtown, MD
- Parts Used:
- W10854242
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Old skirts tabs broke off with age
Just replaced them.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dan from Olalla, WA
- Parts Used:
- WP3192741
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
change over from Natural Gas to LP and install cooktop from Electric to gas
removed old electric cooktop and install gas line and gas cooktop and change from natural gas to LP remove and replace orifice with new ones from kit, my cooktop called for 2 black orifices in the two small burners but did not come in the parts kit that I orded so I used 2 red orifices and it seems to work just fine.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- scott from carrollton, GA
- Parts Used:
- WP3424F031-81, WP3424F030-81
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
old drip bowls needed replacement
The repain involved removeing two screws in each of the burners. Easy to fix. Looks like new now for a fraction of the cost of replacement.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Geri from Brand Haven, MI
- Parts Used:
- 814323
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
One of the pads on the bottom of the grate kept falling off.
I was able to order the part I needed. The faulty pad had a broken stem.Several pads came in a bag so if I have the problem again I will have the parts on hand. I bought some RTV glue suitable for items at high temperatures; used a probe to make sure the hole in the grate was clear and clean and glued the new pad in place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from Dayton, OH
- Parts Used:
- 814323
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Burner grate pads worn off or missing
I took a jewelers screwdriver and completely cleaned out what was left of the old pads. Then applied a small amount of heat resistant rtv sealant to each hole, slid in the new pads and wiped off the excess. I let everything set overnight. The next day everything was solid. Job was complete. Note I've done this before and did not get the results I did this time. I believe it was the instruction that came with the pads and the tip-off to use the rtv. Thank you PartSelect T.Garr
Was this instruction helpful to you?
Thank you for voting!