91133384101 Kenmore Cooktop - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- James from Jenison, MI
- Parts Used:
- WB13K18
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
no spark at burner
Remove grates,pans and disk. Remove allen screws at each burner. Take a flat blade screwdriver and press in on tabs on each side of front of stove to depress keepers and lift top up. Remove wire, and keeper on bottom of electrode. Reverse for install.
Was this instruction helpful to you?
Thank you for voting!
replaced drip pan and seal
We unscrewed the old drip pan. Then undid the igniter. Next the seal was put on the new drip pan. The igniter was reattached, the drip pan was screwed in place.
Was this instruction helpful to you?
Thank you for voting!
Chipping burner bowl
Remove the two phillips screws. Unplug the ignitor. replace the bowl , ignitor and screws..
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mark from Houston, TX
- Parts Used:
- WB31K5080
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
replacement of burner bowls
First off,I was shocked and pleased at how quickly the parts were speed, next day! I did have to return two bowls and order the correct ones only because it was not clear which bowls were needed and the GE manual had no specifications. The small bowl was easy enough to discern, the medium and large were the challenge. The middle opening on both bowls is the same. I failed to notice on the plates and online that the spark emitter, (I do not recall the correct teen), is closer to the middle opening. After receiving the correct bowls, our gas range looks like new.
Was this instruction helpful to you?
Thank you for voting!
change over from natural to lp gas
i removed the cover over hole that holds the orifice used a 7mm nut driver with butyl rubber tape stuffed inside nut driver, this stuff is sticky and holds orifice in place while positioning over hole.total time about 3 minutes. they worked perfectly.
Was this instruction helpful to you?
Thank you for voting!