Models > 91143475890

91143475890 Kenmore Cooktop

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
This is a drip bowl for your range or cooktop. The drip bowl sits beneath the burner of an electric range and collects any spills that occur while cooking. The bowl is 6 inches in diameter and represe...
In Stock
In Stock
This part is the replacement surface burner or element for your range. It is approximately 8 inches in diameter, and 2100 watts. The surface burner connects to the power source and when it is turned o...
In Stock
This kit comes with the terminal block, mounting clip and wires.
In Stock
In Stock
In Stock
This medallion is located in the middle of the surface burner.
Special Order
No Longer Available
$8.06
In Stock
Special Order
In Stock
$11.53
Special Order

Questions and Answers

Be the first to ask our experts a question about this part!

Common Problems and Symptoms for 91143475890

Viewing 1 of 1
Element will not heat
Fixed by these parts
Fixing Fixing Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Shaohui from East Lansing, MI
Parts Used:
WB17X210
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers
There was no heat on the coils.
I opened the lid, and found that the terminal blocks were burnt, the wires were melted. I ordered one set of terminal block to replace the burnt one, and it worked. Before I started, I shut off the electricity in the whole house to be safe.
48 of 52 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Gregory from Mont Belvieu, TX
Parts Used:
WB17X210
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers, Socket set
Surface burner coil did not work.
TURN OFF ALL POWER TO KITCHEN. Took off all burner coils and plates below them. Lift hood. Locate part. Remove old part and replace with new part in same way as was previously installed. The wire that comes with the kit is actually too much wire, but just arrange it the best you can and leave it....no big deal. I didn't have a magnet , but needed one. The wire from burner coil to switch runs through a harness which is screwed on to the body of the oven (below the range). Be careful NOT to drop it behind oven when taking it out. I dropped it and took forever to get it. That turned a 20 minuate job into an hour and a half. Otherwise this is an easy job that anyone can do. Refrigerator compressor is next. Have fun.
23 of 33 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Charles from Carthage, NY
Parts Used:
WB30X253
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver
Large burner would not heat
I ordered the wrong part to start with. (READ CAREFULLY!) I reordered the correct part and it was simple. I unpluged the old element, plugged in the new one replaced the drip pan and trim ring and we were back cooking.
Service was fast, lady I spoke with on the phone to exchange parts was knowegable and nice. Great people to deal wi th.
5 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!