Models > JGC8430CDB11 > Instructions

JGC8430CDB11 Jenn-Air Cooktop - Instructions

Jump to:

All Instructions for the JGC8430CDB11
16 - 19 of 19
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Bill from Rochester, NY
Parts Used:
WP74007749
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
I lost the cap
after I received the cap in the mail, I removed the grillwork and set the cap in place. then replaced the grill and my wife fixed my supper.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
ned from leland, MS
Parts Used:
WPW10475147
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver
would not light
remove two screws then unplug the wires put the wires back on the new one
2 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Charles from Buena Park, CA
Parts Used:
W11087445
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Wrench (Adjustable)
Gas explosion due to bad Gas Pressure Regulator
First step is to turn gas off to cook top and also disconnect power to the unit. Than using a crescent wrench disconnect the gas line going to the unit from the Regulator. Than again using the crescent wrench disconnect the regulator from the bottom of the unit. Next remove the nipple that connects the gas line to the regulator from the old unit. Apply new pipe dope to the threads and screw it into the new one and tighten down. Next install the regulator to the unit and install the gas line to the regulator. once done with the install you can now plug the unit in and turn on the gas. You are now ready to use the cook top again
0 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
edward from nanticoke, PA
Parts Used:
74007735
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
burner porsclend was cracked and would not light
removed grate and cap.unscrewed burner plate.disconnected spark wire and replaced with new part.fired it up .now it workes again.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the JGC8430CDB11
16 - 19 of 19