3860ERS Jenn-Air Cooktop - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Ronald W from Colorado Springs, CO
- Parts Used:
- WP2002F208-50
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Part was corroded
took out the screws replaced the cartridge top, replaced the screws
Was this instruction helpful to you?
Thank you for voting!
Although the knobs where the correct ones, they did not fit over the stems correctly.
I used the blow torch to heat up a small screwdriver till it was red hot. I then quickly applied it to the inside of the new knobs to make the shape more accommodating to the stems size. Once I thought I had about the right size, I heated the screwdriver again and melted the inside of the knob again and quickly pressed the know on to the stem and molded the inside as best I could to the stem.So far so good. Everything is working again.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- HONESTO from HEMET, CA
- Parts Used:
- WP2002F208-50, 715878
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Screw drivers
Two of the screw holes in the new tops do not line up with the holes in the existing pans.
I had to remove the clip attached to the edge of the pan holding the wires so I can push the top down more for the holes to line up. The thickness of the clip prevented the holes to line up.
Was this instruction helpful to you?
Thank you for voting!