JP350AA1AA General Electric Cooktop - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Daniel from chesterfield, MO
- Parts Used:
- WB24X29364
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Cook top control stoped working
Just follow the directions on the website.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Claire from Altoona, PA
- Parts Used:
- WB24X29364
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers, Socket set
Dual burner was only heating on high.
Getting to the control switch was the hardest. Handling our 35" cooktop was tricky. The rest went fairly easy. Just make sure you make a diagram of the colored wires and where they go on the switch. We had to expand the holes in the switch a little to get the old screws lined up.. Putting the cooktop back together was easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Patti from Fort Collins, CO
- Parts Used:
- WB30X38934
- Difficulty Level:
- Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers, Socket set
Cooktop double burner quit heating.
We never could figure out how to get the glass top removed to replace the burner. Looked at several instuctional videos and they never wrong in their description of where the 2 screws were to remove it. We finally called Sears Repair. They came out the next day and fixed the problem. The scres were on the side of the stove unit, not under the oven door. Oh well, atleast it works. Part select is excellent and I would use them again. This is the 3rd time I've ordered parts.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mark from Big Rapids, MI
- Parts Used:
- WB24X29364
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Switch did not function, boiling water spilled onto cook surface , dripped inside switch.
Raised cooktop......took 8 screws from trim plate and cook surface off.....removed 4 more screws off switch mount bracket, removed 2 screws from switch and mount bracket ( switch now free) ...pulled off wires and connectors one at a time, and put the wire on corresponding new switch location.... Took a total of 30 minutes.... Cleaned cooktop surface too! Cautions...don't tighten ANY screw too tight, as stripping will occur.
Was this instruction helpful to you?
Thank you for voting!