ZEU668A1BB General Electric Cooktop - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- anthony g from MOUNT PLEASANT, SC
- Parts Used:
- WB30T10043
- Difficulty Level:
- Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers, Socket set
needed burner replacement
There are 18 sheetmetal screws not 8
The GE SREWS HAVE AN INTEGRATED WASHER which causes the philips head to STRIP these needed to be drilled out!!!
The glass top was GLUED to the sheetmetal box and did not come off without a fight
The GE SREWS HAVE AN INTEGRATED WASHER which causes the philips head to STRIP these needed to be drilled out!!!
The glass top was GLUED to the sheetmetal box and did not come off without a fight
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from Daly Cty, CA
- Parts Used:
- WB23K5053
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers
no power to cook top, house breaker would not reset
Remove screws from 2 sides of cook top, lift out top frame/glass assembly, element controls are to your right. Remove screws on top and bottom of element control assembly to access wiring and inspection. The 4 element controls, 4 heating coils, and all internal wiring were check for shorting, open circuits, and signs of burned parts. My trusty Fluke meter found a Halogen Element control shorted to ground. I order the part from Parts Select.com it came the next day Fantastic Service !! I'm happy, my wife's happy!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mark from Big Rapids, MI
- Parts Used:
- WB24X29364
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Switch did not function, boiling water spilled onto cook surface , dripped inside switch.
Raised cooktop......took 8 screws from trim plate and cook surface off.....removed 4 more screws off switch mount bracket, removed 2 screws from switch and mount bracket ( switch now free) ...pulled off wires and connectors one at a time, and put the wire on corresponding new switch location.... Took a total of 30 minutes.... Cleaned cooktop surface too! Cautions...don't tighten ANY screw too tight, as stripping will occur.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Daniel from chesterfield, MO
- Parts Used:
- WB24X29364
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Cook top control stoped working
Just follow the directions on the website.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Claire from Altoona, PA
- Parts Used:
- WB24X29364
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers, Socket set
Dual burner was only heating on high.
Getting to the control switch was the hardest. Handling our 35" cooktop was tricky. The rest went fairly easy. Just make sure you make a diagram of the colored wires and where they go on the switch. We had to expand the holes in the switch a little to get the old screws lined up.. Putting the cooktop back together was easy.
Was this instruction helpful to you?
Thank you for voting!