Models > AKT3020E-P1143715NE > Instructions

AKT3020E-P1143715NE Amana Cooktop - Instructions

Jump to:

All Instructions for the AKT3020E-P1143715NE
16 - 20 of 20
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Jason from Huntingtown, MD
Parts Used:
12002422
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
Dual right front burner would not modulate temp
It is important to remove the two screws holding in the switch first and from the top with a small screwdriver, then remove the wires. Install the wires back on the switch first to assist in holding the relay close to the scew holes. Otherwise much more of the unit needs to be taken apart.
Was this instruction helpful to you?
Thank you for voting!
Customer:
RANDY from LA MESA, CA
Parts Used:
12002422
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers
Both elements were full on and hard to shut off.
Turn the power off. Lifted the stovetop up and rotated it to stand up in the cabinet. Removed the bottom cover and the knob. Put tape markers on all wires for I.D. reference. Disconnected all wires. Identified knob and detent position of the old switch. You could be 180 deg. out. Unscrewed switch assy. from top and removed. Installed new switch assy. after verifying detent position. Using the helpful diagram provided by PartSelect, wires were attached to the new switch. Attach points on the new switch are in different locations than the old switch, at least on my stove. Some wires will need to be re-routed and stretched a bit to fit but it all works. Turned power back on and tested the elements. All fine. Drilled a hole in the bottom cover to attach a clamp to keep the power cable up and out of the way of pots and pans. The original installer neglected to do this. Installed the bottom cover and set the stovetop back in the proper location in the kitchen counter. Had myself a beer for a job well done! The original repair person said the switch would cost $173.00 and was special order. Then he called back and said the part was unavailable. I asked him if he had checked the Internet and he replied that if I wanted to do a search and find something he would be happy to come back and install it. Let's see, $173 plus, maybe an hour install @ $60? per hour versys $58 for the switch and an hour and a half of my time. I think he's still waiting for my call. Thank you PartSelect.
Was this instruction helpful to you?
Thank you for voting!
Customer:
John from Lancaster, PA
Parts Used:
W10823726
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Screw drivers
Inner element dead
Pulled range away from wall and unplugged it. Pulled smoothtop out a bit to clear retaining clips. Swung top up and unplugged the cable going to top. Removed top hinge so top could be removed. Put top upside down on a table to work on. Removed wires from bad burner and then removed screws holding the burner in place. Replaced bad burner with new one and reversed the previous steps. Range worked like new. PartSelect service was great, received the part in one day.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the AKT3020E-P1143715NE
16 - 20 of 20