IPA1882054 Industrial Air Compressor - Parts

This is an authentic replacement part manufactured for use with Powermate electric air compressors. The head gasket is used to form a seal at the connection between the valve plate and the cylinder he...

It is a genuine item that is supplied by the original equipment manufacturer for use with Powermate air compressors. This is a high-quality replacement for a missing or damaged gasket which provides a...

This is an authentic OEM replacement part that has been sourced directly from Powermate. The petcock on your air compressor is also known as a drain valve. While your compressor is pressurizing air a ...

This is a genuine manufacturer-sourced part which is designed for Powermate air compressors. It is utilized to regulate the air pressure in the tank. Over time components may wear out and begin to fai...

The pressure switch is a genuine Powermate part that is used to replace the original switch that was part of the air compressor when new. The switch assembly is used to turn the pump on or off based o...

This is a genuine OEM sourced replacement valve kit designed for use with Powermate equipment. The purpose of the valve plate is to allow air into the cylinder. Once the piston starts traveling up the...

This is a genuine replacement part sourced from the original manufacturer for use with electric two stage air compressors made by Powermate. When the air compressor reaches the maximum air pressure, t...

This is an authentic OEM sourced part which is specially made for use with Powermate air compressors. The gauge registers pressure readings and allows you to maintain needed pressure. When replacing t...

This is a genuine OEM replacement part that has been sourced directly from Powermate. This 3/8 inch nut is commonly used in the assembly of your air compressor. These nuts can be found at either end o...

This authentic item is supplied directly from the original equipment manufacturer for use with air compressors made by Powermate and Husky. The flywheel attaches to the oil seal and the carrier. When ...

This is a genuine OEM replacement part that has been sourced directly from Powermate. This tube is ? of an inch in diameter and it is 28 inches long. It is runs from a check valve to a discharge port....

This is a genuine OEM sourced part which is specially designed for use with Powermate and Husky air compressors. The breather acts as a valve for the fuel tank, it allows for the air to enter the fuel...