143RII Husqvarna Brush Cutter - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Mark from COLUMBUS, OH
- Parts Used:
- 581685101
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Rear drive wheels bald, no traction
9/16s inch socket, something to prop up one side of the mower (I used a plastic plant pot), and about 5 minutes was all that was needed. Undo the nut on the wheel, remove, replace it with the new one (can't mess it up - just goes on one way which is extremely obvious), replace and tighten the nut -- done. Just that simple. With the new kicks it goes up hill like a champ now (instead of spinning, especially with the grass catcher attached).
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bruce from ALGOMA, WI
- Parts Used:
- 503718201
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
part not same
Ordered on/off switch. My switch had only one wire terminal. Replacement had two. I ran a wire from one to a screw as a ground. Switch worked fine.
Was this instruction helpful to you?
Thank you for voting!