Models
>
143RII
143RII Husqvarna Brush Cutter
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$11.20
Located inside the fuel tank, the fuel filter removes debris before it can reach the carburetor. If your small engine starts with difficulty or idles rough, it may be clogged, restricting the flow of ...
In Stock
$4.99
This is a genuine hex flange locknut for a lawn mower. It attaches to the carriage bolt (sold separately), fastening the axle assembly braces in place. This part is sold individually, however most mod...
In Stock
In Stock
This is an OEM part sourced directly from Husqvarna. This grade 8 hex head screw is made of metal and measures approximately 3/8 - 24 x 1 ? 3/8. This screw is commonly used in lawn mowers, snow blower...
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Mark from COLUMBUS, OH
- Parts Used:
- 581685101
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Rear drive wheels bald, no traction
9/16s inch socket, something to prop up one side of the mower (I used a plastic plant pot), and about 5 minutes was all that was needed. Undo the nut on the wheel, remove, replace it with the new one (can't mess it up - just goes on one way which is extremely obvious), replace and tighten the nut -- done. Just that simple. With the new
... Read more
kicks it goes up hill like a champ now (instead of spinning, especially with the grass catcher attached).
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bruce from ALGOMA, WI
- Parts Used:
- 503718201
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
part not same
Ordered on/off switch. My switch had only one wire terminal. Replacement had two. I ran a wire from one to a screw as a ground. Switch worked fine.
Was this instruction helpful to you?
Thank you for voting!