KSB560AC0 KitchenAid Blender - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Lisa from Lexington, KY
- Parts Used:
- WPW10524701
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The rubber blender foot was missing.
Inserted the replacement rubber blender foot in to the socket. Simply pushed it in. Fit snugly. Thanks for being one of the only places you can get a replacement rubber blender foot!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cristine from Kennewick, WA
- Parts Used:
- WPW10555711
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
old jar had crack in the bottom
ordered the new jar and placed it on the blender! my pkg arrived quickly, packaging was great. great experience!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jose G from Sunland Park, NM
- Parts Used:
- WPW10555711
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
the gear on the jar that meshes to the drive motor broke
There wasn't any repair,just placed the new jar unto the drive motor( the jar comes with the gear ) and it was good as new. The comments that I found on some other repairs and parts on the model helped me decide the problem and what part to order. Great experience !
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- CAT from SEATTLE, WA
- Parts Used:
- WP9708845
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
plugged into transformer at 220 when it was 120
I turned the blender over and pulled off the 4 rubber feet exposing the screws. I then took out the four foot screws. The bottom cover comes off exposing the control panel. I undid the three connections and just pushed (gently) the control panel out--might have to exert a little pressure on the two opposing clips that hold the control panel in. Then I popped the new control panel in and reconnected the three connectors. Put the bottom cover back on and put back the four screws and popped the rubber feet back in. WaLa---it worked!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Duane from Avon, NY
- Parts Used:
- WPW10555711, WPW10279256
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
recessed coupling removal
I tried the method of removing the base, putting the coupling in a vise and turning the shaft(reverse thread). I managed to spread the slot with the screw driver to the point it was no longer an option. I looked on You Tube for ideas and found one. With the base completely assembled, take a flat edged screw driver placed against the coupling (clockwise) strike the end of the screwdriver until the coupling loosens, turn coupling off by hand. I had to beat it, but it worked and now so does the blender.
Was this instruction helpful to you?
Thank you for voting!