PDM125 Hitachi Angle Grinder - Parts

This is a set of two OEM carbon brushes with the wire leads and brush springs attached. Brushes are most commonly replaced because of general wear and tear, which is perfectly normal for this part. In...

This steel ball bearing is a certified replacement part assembled by the original manufacturer. It is used in various Hitachi handheld power tools. Ball bearings such as this allow for reduced frictio...

This is a genuine OEM sourced replacement brush cap, not an aftermarket equivalent. It is commonly utilized on Hitachi power tools. The purpose of this brush cap is to retain the brush in the holders....

The clip is utilized to secure the cord. It is an identical replacement for a missing or a damaged cord clip that was installed on a new unit. Check the diagrams for your specific model for the exact ...

This is an authentic Hitachi replacement part manufactured for use with grinders. The special wheel washer is commonly used to provide spacing between the grinding wheel and the packing gland. This wh...

This is a authentic OEM approved replacement wheel nut used on Hitachi grinders. This part is generally used to secure cutter/grinding wheel to the spindle/shaft. Includes one (1) nut per order. Pleas...

This is a special component which helps to provide a tight fit between connected parts. Over time it may wear out, get damaged or lost eventually requiring a replacement. Check the appropriate diagram...